Question about 1989 Lincoln Town Car

1 Answer

1989 Transmission 302 Looks like a plastic top you spin in the Transmission pan

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 409 Answers

The part in the pan was put in at the factory, it is put in the fill tube to keep dirt out until the dipstick is installed, it is not needed just shows the pan has not been off since the car was new.

Posted on Apr 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the filter located under the battery, that looks like a oil filter?


It's the transmission filter, and your tranny fluid should be changed every 30,000 miles. Saturn decided to try a spin on filter, instead of the traditional paper / frame filter that goes into the transmission pan.

Apr 18, 2015 | 1996 Saturn SW

1 Answer

Hi! We've got a 1989 240 sedan with a transmission problem. Mid drive it lost all power and now won't move in any gear position. The engine seems fine and the transmission oil looks clean. If you give...


have u checked the transmission filter? maybe u could also have a clogged line? it sounds like there could be transmission shavings in ur pan too take it off clean it up and change filter and change the fluids and see if that helpped!

Sep 07, 2013 | Volvo 240 Cars & Trucks

1 Answer

89 F250 460 door sticker says trans code "k" what


Transmission Types : Ford E4OD/4R100, 4 Speed, Automatic Transmission
Comments: w/ Shallow Pan = 20 bolt holes 4 speed

Drive Trains : Four Wheel Drive
Transmission Types : Ford C6, 3 Speed, Automatic Transmission =17 bolts 3speed

What does the dash indicator say and does the stick have an od button on it? there is only 1 3 speed for the 460 and only 1 4speed for the 460

Engines:{300, 302, 351w}, {400, 351m, 460}, {6.9L, 7.3L IDI}, {352, 360, 390, ect.}
Fluid:
Pre '77: Type F
Post '77: Mercon
Display: PRND21
Pan 17 bolts "Utah" shape
Ratios:
1st 2.46:1
2nd 1.46:1
3rd 1.00:1
Trans code: K

so you should have the 3 speed acording to the code
http://broncozone.com/topic/10386-transmission-id-chart/

Feb 27, 2011 | 1989 Ford F 250

2 Answers

How do I determine the model of transmission. I have an 1989 k2500 ext cab 4x4 350ci and od trans


there is a number on the side of the transmission on the passangers above the oil pan near the rear of the pan example 6 YD D 3 187 A All of the information is contained in this # year model make shift built dates locatoin of assemble

Jan 14, 2011 | 1989 GMC Sierra

2 Answers

How to change the filter on the automatic transmission on Honda civic 89?


In the Civic the Transmission Filter is located inside the transmission, you must remove the bottom pan of the transmission, the filter is just below the Valve body, remove all the bolts from the pan and with a large catch pan under the pan gently pry the pan down, it is very messy as there is no drain plug, install the new filter element and then clean off all the old gasket on the transmission pan and the transmission, reinstall the pan with the bolts just finger tight, then evenly tighten the pan bolts down to about 12 foot pounds, add about 1.5 quarts of the correct ATF type fluid and run the car at idle until the transmission is hot, then top off the transmission fluid level, DO NOT OVERFILL.

Nov 22, 2010 | 1989 Honda Civic

1 Answer

How to change the transmission fluid


it is simple but messy, you need to remove the bottom pan from transmission, there is no drain plug, I use a plastic garbage can lid (w/holes drilled in it) to catch the fluid, then reinstall the pan and a new gasket and torque evenly all arouind the pan to about 12 foot pounds, add 3 quarts of fluid and run the engine untilthe transmission reaches at least 185-190 F, then top off trans fluid to fullmark hot.

Jul 29, 2010 | 2003 Acura 3.2TL

1 Answer

I have a 1987 ford f-150 with a 302. I would like to put the 302 into a 1989 ford f-150 that is four wheel drive that currently has a 4.9 in it. would there be any problems with doing this.


302 is a 5.0L v8 engine and 4.9 is a 300ci, 6 cylinder. so you may have problem with transmission, exhaust manifold, motor mounts, vacuum lines/hose, radiator, power steering pump, a/c system, and mostly wirings. not to mention there is a computer in those trucks!

Apr 21, 2010 | 1989 Ford F 150

2 Answers

Where is the transmission modulator located on a 1989 chevy k1500


If it has TH400 Transmission, its mounted L/H rear just above pan.
Looks about 2" Dia with hose in centre.

Jul 31, 2008 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

fordexpert

Level 3 Expert

5467 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...