Question about 1998 Mercury Tracer

Open Question

How much oil is need for a 1998 mercury tracer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Mike258
  • 1498 Answers

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

Ad
emissionwiz
  • 76846 Answers

SOURCE: where is ecm box located on 99 tracer mercury

It is located under the dash, directly in front of the center floor console. The easiest way to access is to remove the console, which is very easy to figure out and do. The console is only held in place with about 6 phillips head screws

Posted on Jan 24, 2009

ZJLimited
  • 17970 Answers

SOURCE: I need a diagram of a how to install a serpentine

1998 MERCURY TRACER - L4 2.0L 1989cc 122ci GAS FI N P

Belt Routing Diagram / Multiple Accessory, w/A.C.

8e6e46f.jpg


More details HERE

I hope help you (remember rated this help) Good luck.

Posted on Sep 18, 2009

emissionwiz
  • 76846 Answers

SOURCE: were is the horn on a mercury tracer 1998

the horn is not the problem here, this is

In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to disarm the airbag system can result in an unexpected Airbag deployment and possible serious personnel injury disconnect the battery 30 minutes prior to start of work.

Posted on Apr 03, 2010

ZJLimited
  • 17970 Answers

SOURCE: belt routing diagram for 1997 mercury tracer?

Check this...

f307936.gif

Hope helps.



Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 mercury tracer:oil light not on but the engine sounds like it is not getting oil to the top.


Are all the valve follower making noise? If so you may have a plugged oil passage. Try pouring in a can of "BERRYMAN'S CHEMTOOL" (get it at the auto parts store), it may dissolve the sludge and gunk and quiet the noise, if not it will need to have the valve cover removed and an inspection performed.

Sep 22, 2016 | 1998 Mercury Tracer

1 Answer

Looking for the starter relay in a 1998 tracer


1998 Mercury Tracer is equipped only with a 2.0L MFI SOHC SPI engine (Multiport Fuel Injection, Single OverHead Cam, Split Port Induction). This vehicle does not use a starter relay. Power from the ignition switch goes through the Clutch Switch (manual transmission) or the Neutral Safety Switch (automatic transmission) then directly to the solenoid at the starter. The solenoid is serviced only as part of the starter assembly. (SEE PICTURE)


dttech_180.gif

Aug 30, 2011 | 1998 Mercury Tracer

1 Answer

What positions do the Cam Shaft and the Crank Shaft need to be in when replacing a timing belt on a 1998 Mercury Tracer?


Just mark the cam and crank shaft in the position that it is in before you take the timing belt out

Jun 16, 2011 | 1998 Mercury Tracer

1 Answer

1998 mercury tracer evap canister needs to be replaced,where is that located


It's in the rear, driver side, near gas tank. under this plastic cover.




snorkelbobby_56.gif

May 13, 2011 | 1998 Mercury Tracer

1 Answer

Computer problems


its located below the center of the dash, heres a diagram to help pinpiont it, hope this is helpful.d3f9ae7.gif

Jan 24, 2010 | 1998 Mercury Tracer

1 Answer

Where can I buy fuses for my 1998 Mercury Tracer


i think theres a autozone store near you there? you can buy any part through them

Jan 22, 2010 | 1998 Mercury Tracer

1 Answer

1998 mercury tracer. overheated while waiting in


It might be a bad relay or a bad engine coolant temp sensor. Fan is likely good. Might have 2 relays. See owner manual.

Dec 14, 2009 | 1998 Mercury Tracer

1 Answer

What oil is needed for a 98 mercury tracer with high mileage


normally, 5w30 for winter, and 10w30 for summer, i recommend castrol motor oil to all my customers.

Nov 02, 2009 | 1998 Mercury Tracer

2 Answers

Need to know location of blower relay to be able to repair car


its under your hood engine bay area usually on the fender. ITLL BE A LITTLE BLACK BOX. with a cover on top.open cover and you will see relays and some big fuses.

Oct 07, 2009 | 1998 Mercury Tracer

1 Answer

I need a diagram of a how to install a serpentine belt on a 1998 Mercury Tracer with air.


1998 MERCURY TRACER - L4 2.0L 1989cc 122ci GAS FI N P

Belt Routing Diagram / Multiple Accessory, w/A.C.

8e6e46f.jpg


More details HERE

I hope help you (remember rated this help) Good luck.

Sep 18, 2009 | 1998 Mercury Tracer

Not finding what you are looking for?
1998 Mercury Tracer Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...