Question about 1998 Mercury Tracer

Open Question

1998 MERCURY TRACER GS IDLE PROBLEMS - 1998 Mercury Tracer

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Mike258
  • 1498 Answers

SOURCE: serpentine belt for 1998 mercury tracer

Hey there MSM,

  • Get a 14mm or 9/16" socket and a long handled ratchet or breaker bar.
  • Get the belt around all the pulleys except the A/C compressor or Alternator. The routing diagram is on one of the radiator supports.
  • The tensioner pulley is near the Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley.
  • Slowly pull the ratchet toward the center of the engine. The pulley will pivot on the arm allowing you to get the belt on the final pulley.
  • Slowly release the tension.
  • You're done
Mike

Posted on Dec 14, 2008

Ad
  • 4 Answers

SOURCE: 1993 mercury tracer

To replace the headlight on a 1993 Tracer you must turn the black plastic retainer ring counter clockwise and then pull back gently. The ring and bulb should then slide out toward the engine.
Carefully grab the sides of the plug and pull the bulb out.
When replacing the bulb make sure not to touch the glass part or it will cause the bulb to burn out sooner. Place the black ring back over the bulb with the open end towards the glass part of the bulb. Fit the wiring onto the back of the bulb and insert the bulb back into the reflector. The black plastic ring has notches that fit over protrusions. Turn the black ring clockwise and your done. Test the headlight. Happy Driving

Posted on Jan 28, 2009

MNfisherman
  • 11896 Answers

SOURCE: replacing door speakers in a mercury tracer

first remove any screws in door panel, then remove lock and window controls, then take flathead screw driver and SLOWLY pry panel off door. You now will have access to speaker. Speaker is held by 4 screws and wire harness that unclips.
Reverse procedure to reinstall. Door panel pops back in the wholes to reattach

Posted on Jun 27, 2009

ZJLimited
  • 17970 Answers

SOURCE: I need a diagram of a how to install a serpentine

1998 MERCURY TRACER - L4 2.0L 1989cc 122ci GAS FI N P

Belt Routing Diagram / Multiple Accessory, w/A.C.

8e6e46f.jpg


More details HERE

I hope help you (remember rated this help) Good luck.

Posted on Sep 18, 2009

ZJLimited
  • 17970 Answers

SOURCE: belt routing diagram for 1997 mercury tracer?

Check this...

f307936.gif

Hope helps.



Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low idle 95 mercury tracer


The fuel filter on a 1995 Mercury Tracer Trio is on the firewall closest to the bottom of the driver's side. If you're looking at the engine from the front of the car you'll see the battery. $6.85 is the average price for a fuel filter.----------------------------------------------------------------------------------------------
Motorola 711 Programmer

Mar 23, 2013 | 1995 Mercury Tracer

1 Answer

I have a 1998 mercury tracer it has been giving me alot of problems latley i am planning on getting ready to buy a new car in febuary but i need this one to last a little longer the car runs ok but...


You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jun 07, 2017 | 1998 Mercury Tracer

1 Answer

Looking for the starter relay in a 1998 tracer


1998 Mercury Tracer is equipped only with a 2.0L MFI SOHC SPI engine (Multiport Fuel Injection, Single OverHead Cam, Split Port Induction). This vehicle does not use a starter relay. Power from the ignition switch goes through the Clutch Switch (manual transmission) or the Neutral Safety Switch (automatic transmission) then directly to the solenoid at the starter. The solenoid is serviced only as part of the starter assembly. (SEE PICTURE)


dttech_180.gif

Aug 30, 2011 | 1998 Mercury Tracer

1 Answer

How do i do an idle adjustment on a 1999 mercury tracer?


The idle is controlled by the computer. The idle speed cannot be adjusted. Is it idling too high or too low?

May 29, 2011 | 1999 Mercury Tracer

1 Answer

Computer problems


its located below the center of the dash, heres a diagram to help pinpiont it, hope this is helpful.d3f9ae7.gif

Jan 24, 2010 | 1998 Mercury Tracer

1 Answer

Where can I buy fuses for my 1998 Mercury Tracer


i think theres a autozone store near you there? you can buy any part through them

Jan 22, 2010 | 1998 Mercury Tracer

1 Answer

I need a diagram of a how to install a serpentine belt on a 1998 Mercury Tracer with air.


1998 MERCURY TRACER - L4 2.0L 1989cc 122ci GAS FI N P

Belt Routing Diagram / Multiple Accessory, w/A.C.

8e6e46f.jpg


More details HERE

I hope help you (remember rated this help) Good luck.

Sep 18, 2009 | 1998 Mercury Tracer

1 Answer

Where is rear wiper switch in mercury tracier gs sw 1998


on the end of the wiper stalk on the steering colum

Apr 04, 2009 | 1998 Mercury Tracer

Not finding what you are looking for?
1998 Mercury Tracer Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...