Question about 2004 Chevrolet Silverado 2500HD

1 Answer

Pitment arm and idle arm what dose it look like

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

The pitman arm is on the steering gearbox it connects gearbox with tie rods idler arm is on the right side of truck same place you will see two arms about 6" long that are basically pivot points for steering linkage

Posted on Apr 28, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can i tell if the struts need replaced or the control arm?

jack car under controll arm put pry bar under tire and lift see if tire has pplay if it dose controll arm bushings and or balljoint is bad. look at strut if its leaking its no good or rock car up and down a few times if after you stop rocking it it bounces more than two times strut is bad. could also be upper strut plate

Dec 16, 2012 | Cars & Trucks

1 Answer


if you have all the tools; balljoint remover and all necessary tools to take tire ,idle arm. about 2 hrs by yourself at most.

Apr 19, 2011 | 2008 Ford Fusion

1 Answer

The ball joint n the pitment arm that connects to the great box is that an upper or lower ball joint for a 1999 nissan frontier 2wd 4c

lower, just google it to find some things or go to automotive to find more about your truck.

Mar 23, 2011 | 1999 Nissan Frontier

1 Answer

Engine stalls at idle at 35 mph at 60 mph speeds

I think you mean the engine stalls or cuts out at Idle/30/60 mph.
More info wanted,as first is it a Man/or Auto ,what engine have you got 6 or v8??? When last servised by who,How many miles on the clock,dose it smoke when driving or starting ,are the revs ok on idle ,,about what temp dose it run at the 30/60 mph etc etc???
PLEASE send all info, ..

Nov 30, 2010 | 1997 Jeep Grand Cherokee

1 Answer

My 2001 Blazer starts but as soon as I take my foot off the gas it idles right down and dies.

how dose it drive under load? dose it act up other then idle. have u done a fuel presser test

Nov 21, 2010 | 2001 Chevrolet Blazer

1 Answer

Where do i turn up idle or how do i turn up idle on 93 cadillac deville

for the most part u dont if it dose not idle right there is something wrong .

Nov 13, 2010 | 1993 Cadillac DeVille

1 Answer

Idle at 2500-3000

If you idle is high then your idle air control valve may be bad. (IACV) Basically what this does is changes the idle of your car during warm-up dependent on the temperature outside. When it is cold this valve makes it idle higher until it reaches operating temperature. If it is idling real high it could be that the valve is dirty or the electronics in it have gone bad.

Nov 19, 2009 | Honda Accord Cars & Trucks

1 Answer

Wont stay tight wiper arm

The wiper arm has teeth on it that hold it the spindle, those teeth wear out and let the wiper arm flop all over. You need a new wiper arm, if it is under warranty I'd take it in, if not changing awiper arm is easy. I've seen this on several kias, and also on other foriegn cars. It is just a bad design in my opinion.

Apr 30, 2009 | 2005 Kia Rio

1 Answer

Idle arm replacement Chevrolet Blazer 2001

if the new arm is not the same as the old arm , then it is not the right unit
take the vehicle to a front end steering specialist shop for a proper diagnosis of the problem

Jun 13, 2017 | 2001 Chevrolet Blazer

1 Answer


dose it start again?? dose it have acceleration in the first 20 second ??
if not . check the fuel pressure , fuel filter & fuel injectors
check and give us more details to help you again
with my best wishes

Jul 08, 2008 | 2000 Daewoo Lanos

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides