Question about 2005 Hyundai Elantra

1 Answer

I have a hyundai elantra 2005 - the power antenna mast has broken- how do i replace it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 106 Answers

Pull the inside panel down by the antenna.and from there its self expanitory

Posted on Apr 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tacoma(1997) power antenna mast with broken cord will not come out after the chrome nut is removed. Any suggestions? Antenna motor still works.


Power Antenna Mast Replacement 97 fjz-80 ' IH8MUD Forum

forum.ih8mud.com > Forums > Toyota Tech Forums > 80-Series Tech
Oct 1, 2010 - I'm looking for a "how to" on replacing the OEM power mast on a 97 LC. ... The only tricky part is removing the funky nut that holds the mast in. .... what to do with the radio mast on my newly acquired 1997 Lexus LX450. ... if I have a broken cable, but the antenna itself comes right out of the top with no cable.

How to rebuild the power antenna - Cadillac Forums

www.cadillacforums.com > ... > Cadillac Tech Tips - How to fix it

May 9, 2009 - 15 posts - ‎12 authors
Remove the liner to access the antenna and disconnect ANY of the two ... If notlocked the motor receives continuously power and will drain ... Broken nylon wire lifting/lowering the antenna mast 4. ... The motor shaft comes out from the plastic casing after you take out ... Do not lubricate the cable or the mast.

Saabnet.comt Broken Antenna FAQ - The Saab Network

www.saabnet.com/tsn/faq/antenna.html
If the cable broke in the antenna, you need to remove the antenna to remove the ... take a 17 mm wrench and remove the nut over the antenna where the mast comes out of the body. ... Hopefully the chrome sleeve will come with the old mast. ... Be careful not to drop them down too far. get the motor assembly on a bench ...Missing: tacoma ‎1997

How To Repair A Broken Car Antenna -EricTheCarGuy ...

? 20:53
https://www.youtube.com/watch?v=zcKwFto9_s0
May 24, 2013 - Uploaded by EricTheCarGuy
This video shows one way you can deal with a broken antenna. ... Find out why ... this video is that I did ...Missing: chrome

Jan 12, 2016 | 1997 Toyota Tacoma

1 Answer

I am replacing the power antenna mast on a 2005 hyundia sonata...I have turned the radio on but cant get the cable of the portion of the old broken mast to come out


You need to remove the top cap cover, this is the ring on the top of the antenna that holds it to car then use some small needle nose pliers to pull the rest of the mast, if theres a broken part stuck inside then you will have to remove the ant and open the side to remove the rest of it, then reasmeblt unit and put back on car then slide new one in and have someone turn radio off as you feed ant in, if it doesnt go all the way in then turn radio on but dont let it come out then turn it back off fast and feed the rest of ant in, once its in place install the top cover ring to lock it in place. hope this helps.

Dec 24, 2010 | 2005 Hyundai Sonata

2 Answers

Power Antenna Mast


easy way permanent mask both ways have to run cable. I bought me the amplified glass ant strip that goes on front windshield. A lot better for my car.

Jan 01, 2010 | 1988 Chrysler LeBaron

1 Answer

Power antenna broke and I need to replace it. How


Buy replacement antenna mast. Remove old one by unscrewing the retaining cap nut. Turn on the radio & let the antenna cable run all the way up while you pull on it to remove it.
Install the new antenna mast by turning the radio 'off' so the spool inside goes back to its beginning while you feed the cable of the new antenna down into the antenna mast hole.
Once the cable is all the way down, reinstall the retaining nut/cap and turn on the radio to allow the spool to run the antenna 'UP.'... cycle the radio ON and then OFF several times allowing the antenna to move all the way up and all the way down.
That's it!

Sep 28, 2009 | 2001 Hyundai Sonata

1 Answer

How to replace thunderbird antenna


please rate service.

Automatic Electric Antenna
Removal
  1. Lower electric antenna (18850) .
  1. Remove rear retaining screws of RH front wheel splash shield for access to antenna lower retaining bolt.
  1. Remove lower retaining bolt.
  1. Remove radio antenna nut (18865) from top of motor tube and remove electric antenna through fender/splash shield access.
  1. Disconnect signal cable and motor wire connector(s).
Installation
  1. To install, reverse Removal procedure.
  1. Tighten top radio antenna nut to 6-8 Nm (54-70 lb-in).
  1. Tighten lower electric antenna retaining bolt to 5.8-7.8 Nm (51-69 lb-in).
  1. Check operation of electric antenna and radio chassis .

    Automatic Electric Antenna


    1faf511.gif

mast
Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly.
Removal
  1. Remove radio antenna nut (18865) and radio antenna stanchion (18919) .

    ssd~us~en~file=l6389b.gif~gen~ref.gif

  1. Loosen retaining nut inside tube using 14 mm (9/16 inch) socket, and slide nut part-way up mast.
  1. Raise antenna to run plastic drive wire at bottom of mast out of motor. Note direction of teeth on plastic drive wire.
  1. Saw off damaged portion of antenna mast. Remove burrs from mast and slide nut and contact tube off stationary tube.
Installation
  1. With the teeth on the plastic drive wire facing toward motor on antenna, push end of plastic drive wire of replacement mast assembly down into tube. Push it around curve at bottom of tube until end enters drive mechanism.
  1. Run motor down while pushing on plastic drive wire until about 305 mm (12 inch) of wire has been drawn into the tube. Stop motor and insert bottom of antenna mast into tube. Lower mast.
  1. Slide contact tube and radio antenna nut down antenna mast. Tighten nut to 0.45 Nm (4 lb-in).

  2. Raise and lower antenna several times to ensure proper operation.
651247a.gif

Jul 09, 2009 | 1995 Ford Thunderbird

1 Answer

Antenna


if its not electronic.you simply push the intenna downward back into the lower portion of the mast.
have a good day DB

Jan 31, 2009 | 2005 Hyundai Elantra

2 Answers

Replaceing a broken antenna mast on a 2005 Ford focus


I am pretty sure if you remove the inside dome light cover and take out the light there is a bolt and nut under there for the base that you can unscrew. By the way where did you buy the parts from, Ford is telling me $70 for the antenna whip?

Jan 21, 2009 | 2005 Ford Focus

1 Answer

Power antenna wont go down


The flex drive cord that raises the antenna mast and lowers it is most likely broken, you can replace just the mast and drive cord.

Nov 21, 2008 | Hyundai Motor 2002 Sonata

Not finding what you are looking for?
2005 Hyundai Elantra Logo

702 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...