Question about 1986 Toyota Xtracab

2 Answers

Num 1 dead , changed plug, wire ,rotor, cap, injector, does have compression runs fine sometimes , 1986 toyata dolphin motorhome 22re

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My toyota hilx 4 runner 4y engine starts but it idles rough and when i apply throttle it dies and wont rev or run right points have spark backfires

Posted on Apr 24, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Toyota Master
  • 1,851 Answers

The only thing left is the cam lobe it self. Run all new plugs for just one week. Pull the plugs - laying them out each plug for each cylinder - -mark them. Change them to NEW again - in one week - pull them and compare them with the new plugs. Some times you just get back plugs too so if you want to short cut it - change the plugs say - that cylinder with number 3.
Also - how old is the timing chain? This happens a lot with stretched chains - That is an old engine so I would seriously consider the timing chain being stretched. Inspect it as a precaution. I would replace it if you do not remember when it was changed to the month and year.
num 1 dead , changed plug, wire ,rotor, cap, - dabc498.jpg

Posted on Apr 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

IF THE ROTOR POINTS TO NUM 1 CYL DOES IT ALSO POINT TO THE NUM 1 PLUG TOWER ON CAP


Don't worry about actually pointing toward # 1 cylinder, just the tab under cap that goes to # 1 spark plug wire. # 1 cylinder needs to be at TDC on compression stroke, and rotor pointing at # 1 wire tab under cap.

Jan 15, 2014 | Dodge Ram 1500 Cars & Trucks

1 Answer

It has a misfire ,we changed the plugs and the coil pack and wires still has a misfire what else could it be


Gas or compression. Check the injector circuit on 1 and 3. Are they pulsing, to put gas in the cylinders? Do a compression test to rule out loss of compression as cause for the misfire.
Kind of odd it would be 1 and 3, but that is one right after the other in the firing order of 1-3-4-2...so, you have a single coil? So you have a distributor-examine closely the distributor cap and rotor if those were not changed too, with the plugs and wires. Look for damage, little black tracks that indicate shorting of the spark, maybe damage at the electrode tips on the inside of cap on 1 and 3 plug wire towers. Most people change the cap and rotor when doing the plugs and plug wires.
Just a possibility also, that the injector ground wires for 1 and 3 might share the same ground. That is to say, they might splice together before going to the computer where the computer internally grounds injector circuits to cause pulsing. Well, those are my thoughts, good luck. And let me know what you find, always interested.

Dec 13, 2013 | 1998 Dodge Neon

2 Answers

It runs rough sometimes it dies, I have tuned it up , plugs dist cap, wires rotor the computer , It has very poor gas milage .it has a 2300 with automatic trans,


have the intake gasket checked. spray carb/choke cleaner around intake gasket and if rpms change then you have a bad gasket which causes rough idle bad fuel econ

Apr 09, 2011 | Ford Ranger Cars & Trucks

1 Answer

1986 toyota truck 4x4, 4cyl, 22RE (fuel injection) I have replaced all the hoses, tested everything that can be tested, replaced fuel pump, timing belt, O2 sensor, a few sensors, dist. cap, rotor button,...


The igniter interprets signals of time and position from the distributor, fits the efi ecu with information and then the ecu gets back to igniter to tell it when to fire specific cylinder, we used to have problems with the distributors and also igniters.

Jan 11, 2011 | Toyota Pickup Cars & Trucks

1 Answer

86 S-10 Blazer 4X4 auto trans 2.8 with AC. will not run now. changed fuel pump couple months ago ran fine till now. 34 code changed MAP sensor code cleared. found bad rotor changed rotor, Dist. cap. Plugs,...


Your injectors may be shot ... That might explain the code. As horrible as this is to ask, you seem pretty handy with your tools, do you by chance have a carburetor, perhaps a quadrajet or whatnaught, to hook up just for a second to see if your ECU/fuel injection system is FUBAR'd?

Oct 31, 2010 | 1986 Chevrolet S-10 Blazer

1 Answer

What is the proper plug wire order on my distributer cap?


18436572 to the left of the square plug on the cap is # 1 plug ( where the power plug and distributor plugs are ) then clockwise from that is 8436572 assuming you have the 5.0 or the 5.7 engine the rotor has to point at the driver side front plug on engine thats number 1 with the engine at top dead center plug out engine on compression stroke timing mark on tdc or 0 degrees

Sep 15, 2010 | 1986 Chevrolet G20

2 Answers

1986 f-150 302 which way does the rotor button face if your piston is up


If # 1 cylinder is on compression stroke and at TDC, the ignition rotor should be pointing at the tab inside cap for # 1 spark plug wire.

Nov 01, 2009 | 1986 Ford F150 SuperCab

1 Answer

How to start the firing order on the distri butator cap


Turn the #1 cylinder to top dead center, on the compression stroke. Remove the cap and see where the rotor button is pointed. This is the #1 cylinder plug wire position. Start from here, and clockwise run 1-8-4-3-6-5-7-2.

Jun 08, 2009 | 1986 Chevrolet C1500

1 Answer

87 4Runner 22RE problem


Replace the number one injector; it is sticking open.

Oct 07, 2008 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...