Question about 2004 Chevrolet Malibu

1 Answer

Where is the turnsingle flasher located on 2004

Where is the turnsingle flasher located on 2004 chevy malibu

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 17,970 Answers

Technically --you dont have a flasher.....The 4 way button on the dash is a combination turn/ hazard flasher control "MODULE"...

This is a common problem with these switches. I have replaced several of them over the last few months. The switch can be replaced without all of the disassembly that is recommended. I have done it. There is a screw holding the switch into the dash behind the bezels, but it is possible that it can be done without spending hours on it. The Grand Am/Prix cars were all the same, just a slightly different design.

Hope this helps.

Posted on Apr 28, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy Malibu 2004. While driving the turn signal sound came on on its own. Won't go off at all- the rhythm isn't consistent either.


The flasher unit may be defective. On your '04 Malibu, it might be combined with the hazard flashers and be an electronic marvel-as in "pricey". The little flasher relay used to be real simple and cost 2 or 3 dollars- but not anymore. If too expensive, one from a salvage yard should be fine.

Nov 14, 2013 | Cars & Trucks

1 Answer

Where are the turn signal flashers located in a 2004 Chevy Malibu Maxx LT ?


check the bulbs when you get rapid flash normally 1 pf the bulbs are out

Jul 06, 2013 | 2004 Chevrolet Chevrolet Malibu MAXX LT

1 Answer

I have 2004 malibu classic my problem is the turn signal is keeps on clicking and clicking


Most of the time the problem is the 4 way flasher switch located in the dash, the signal flasher is part of this switch so replacing the 4 way flasher switch solves the problem.

Mar 23, 2013 | 2004 Chevrolet Malibu

2 Answers

Where is the fuel pump located on a chevy malibu


It's located in the gas tank and to replace it, your going to have to drop the gas tank.
Thank you for using fixya and if you are going to replace the fuel pump your self. Make sure you also replace the wire harness from the frame to the fuel pump.

Jun 03, 2010 | 2004 Chevrolet Malibu

3 Answers

Where does the flasher go on a 98 chevy malibu


Replacement The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
  1. Remove the bezel from the ignition switch.
7f58edd.gif
Remove the bezel from the ignition switch

Carefully remove the instrument panel accessory trim plate.

9f5c3cc.gif
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .

bd28884.gif
. . . then gently pull the accessory trim plate away

Detach the electrical connector from the hazard warning switch.

daa6205.gif
Unplug the electrical connector from the hazard warning switch . . .

Unfasten the screw securing the hazard warning switch and remove the switch.

c506713.gif
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle


Installation is the reverse of removal.

Dec 01, 2009 | 1998 Chevrolet Malibu

1 Answer

2004 Chevy Malibu driver's side turn signal doesn't work


resistance from the bulbs activate the flasher, so if a light is out it won't flash, could be a ground or an open circuit, time to check wiring

Nov 24, 2009 | 1997 Chevrolet Camaro

4 Answers

Turn signal or emergency flashers wont work. parts store says they cant find a flasher for them. I checked the turn signal fuse and its good. Any ideas?


The flasher is located above the fuse panel. The relays are built into the switch itself. They have a recall on the 4 way flasher switch because it is faulty and causes blinkers not to turn on. Very common Malibu and other Gm problem

Nov 20, 2009 | 2002 Chevrolet Malibu

1 Answer

Where is the flash located in a 2002 chevy malibu


It is on the Fuse panel under the Dash on the Drivers Side at the Top Right Corner of the Panel.

Jan 18, 2009 | 2002 Chevrolet Malibu

Not finding what you are looking for?
2004 Chevrolet Malibu Logo

278 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...