Question about 2004 Saturn VUE

1 Answer

2.2L 4 cylinder spark plugs, replacement - 2004 Saturn VUE

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

On top of you engine is a cover that house the ignition module and underneath that cover you will find you spark plugs.

Posted on Apr 28, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: 2001 hyundai santa fe 6

HI......
OK. just follow the number on the ignition coils.
And the number on the cylinders are.
The FIREWALL side are 1,3,5, Starting from the belts location.
The RADIATOR side are 2,4,6, Starting from the belts location.
The coil with number 1 go to cylinder 1. as the same way the rest of the coils and cylinders.

OK... I hope this solve your question .

THank you for use fixya.

Posted on Jul 25, 2008

  • 398 Answers

SOURCE: 1987 Mazda P/U 2-2 cu in engine distributaor & plug firing orde

check this out http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528007698a

Posted on Mar 07, 2009

  • 83 Answers

SOURCE: how to change spark plugs on 2 lt 4 cylinder chevy

Remove spark pug wires from spark plugs. On this engine, it is located on the top. Remove all plugs with socket and ratchet. The socket size is a 13/16th. The new plugs should be pregapped if the correct ones where given to you. But check the factory spec for the gap. There is a sticker in the engine compartment that should tell you the gap. Gap the plugs as required and install them. DO NOT OVERTIGHTEN PLUGS, Double check factory tightening specs for plugs. Use a torque wrench to tighten plugs to required torque. If this this information is not available to you, then snug will be fine.

Posted on Jul 23, 2009

  • 110 Answers

SOURCE: i have a 99 grand am SE 2.4 4 cylinder and my

A misfire doesn't always have to be ignition... it's just the most common cause. Faulty or plugged injector, low compression. You need to check fuel pressure and test the fuel injector flow. Then check compression. If you don't have tools for these tests, take it to someone who does. Testing is much cheaper than throwing parts at the problem.

Posted on Feb 25, 2010

SOURCE: 99 dodge caravan #4 cylinder misfires, i replaced

This is a known dodge issue replce the injector!!!!! done deal

Posted on May 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine code cylinder 4 miss fire do you need to replace ignition coil with plug and could this be caused by leaving battery unhooked for 4 days


Depending on the actual code, it may not be a spark problem at all.
Code 304 means cylinder 4 is not producing power, which could be something mechanical, spark, or fuel related.
You would check for spark first, and you could replace the plug to see what happens. But if the coil is firing a plug outside the cylinder the coil would probably be ok.

Apr 02, 2016 | Cars & Trucks

2 Answers

Misfiring engine


if some are firing then the voltage is right, something is happening at the cylinders that are not. if you take the spark plug out on a non firing cylinder and leave it connected and hanging from the wire you can turn the engine over and observe the spark, if it sparks then you can rule out the coil.

Dec 24, 2015 | 2006 Suzuki Forenza

2 Answers

Code po304 cylinder four misfire on 1999 ford explore sport fuel injected 4.0 litre 2wd


you have a bad spark plug wire on cylinder 4 or your ignition coil
(coil pack) is bad.

here is a good guide to testing coils and wires if you need it
How to Test the Coil Pack Ford 3 0L 3 8L 4 0L 4 2L

Jan 15, 2015 | Ford Cars & Trucks

1 Answer

Crossfire misfire 4/5


DTC codes that will trigger P0304 Misfire Detected Cylinder #4 & P0305 Misfire Detected Cylinder #5.

Possible Causes:
- Improper spark plug at cylinder
- Insufficient compression at cylinder
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder
- Fuel injector may be faulty

Possible Solutions:
- Perform Injector Service
- Replace Spark Plug
- Replace Injector
- Replace Ignition Coil

Jan 17, 2011 | Chrysler Crossfire Cars & Trucks

1 Answer

Hi - I would like to reset the timing on a 1993 Mazda 626 2L 4 cyl engine. Could you please help me.


timing an engine is a time consuming process to begin timing an engine you must 1. find the 1 cylinder 2. remove the timing belt cover 3. remove the spark plug form the 1 cylinder 4. put a screwdriver into the spark plug hole 5.rotate the timing belt until the cylinder is at the top of the chamber (thats what the screwdriver is for) 6. mark the top of the timing wheel with a pastel marker 7. with a timing light set the idle speed to the factory settings if you dont have a timing light you can normally get it fairly close by listening

Jan 09, 2011 | Mazda 626 Cars & Trucks

2 Answers

Mazda Eunos 500 - Engine lacks power - investigation reveals strong sparks on all cyls fuel at all cyls compression to specification on all cyls timing ok. Removing spark plug lead on cylinder one makes no...


You said compression is good then i would say you may have a bad coil , unless one coil runs all cylinders, but could still be a coil,,next thing i would check would be the injector make sure it gets a pulse if it does then try switching injectors from that cylinder to another cylinder and see if the weak cylinder changes with the injector change, if it does then you have a bad injector,

Jun 14, 2010 | Cars & Trucks

1 Answer

Replace spark plugs on a 2008 4 cylinder tribute


This is a fairly easy job. Do each cylinder one by one (removal and install), make sure to reinstall the coil on the same exact cylinder (DO NOT MIX UP). 1. Remove coil retaining scre 2. Pull upward on the coil to remove. 3. Remove spark plug (using a spark plug socket). 4. Properly gap new spark plug (if applicable). 5. Apply sprark plug anti-seize compound on plug threads. 6. Install plug. 7. Aplly coil boot grease on the coils' rubber boot tips. 8. Reinstall coil.

May 22, 2010 | 2008 Mazda Tribute

2 Answers

My vitara p reg 2L started smoking on start up, now it is misfiring any ideas where i start, I can't see any spark plugs in the engine-maybe i'm blind or stupid


Many new cars hide most of the engine underneath plastic covers that must be removed to find anything. The smoking problem may or may not be serious, but it's likely that the spark plugs will show black oily deposits on the interior insulators. Cleaning or replacing the plugs will usually make the engine run ok for awhile, but with continued smoking, it will foul the plugs again. If all the plugs are fouled, then look for something like a bad PCV valve that creates crankcase pressure when plugged. Worn out valve seals which allow oil to leak into the cylinders can account for smoking only on start-up. These seals can usually be replaced without pulling the cylinder head. Hope this helps!

May 21, 2010 | 1999 Suzuki Vitara

2 Answers

My check engine light is on and the code is reading p0304 what could be the problem


You have a Misfire at Cylinder #4 meaning:
Dirty, fouled or malfunction Spark Plug at #4 Cylinder. Remove the Spark Plug and check the igntion (spark end).
Ignition (Spark Plug) Wire malfunction for #4 Cylinder.
Misfire from the Coil/Distributor at the #4 connection from Cylinder #4.
Get a Spark Plug/Wire/Coil/Distributor tester and check the Spark Plug, Wire and Coil.
I always recommend changing everything in sets meaning: Change all Spark Plugs and Wires.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Feb 18, 2010 | 2003 Ford Expedition

1 Answer

Spark on only 2 of the 4 cylinders


On dis ignition systems if you have an open circuit plug wire you will lose spark on both cylinders of the coil. So however you are checking for spark,(screwdrivers or spark testers) Check cylinders 1 and 4 at the same time. A good way to eliminate the possibility of a bad plug wire is to take both wires off the coil and start the engine. Spark should jump from the coil tower to the coil mounting bolts. If it doesn't replace the ignition module.

Jun 11, 2009 | 1990 Oldsmobile Cutlass Calais

Not finding what you are looking for?
2004 Saturn VUE Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...