Question about 2007 Chevrolet Silverado 2500HD
There is a little aluminum stick in the assembly holding it in. On the top of the headlight twist the stick and remove it. It will look like a tent stake. Remove this stick and then the head light assembly will almost fall out.
Posted on Apr 28, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Oct 31, 2015 | 2008 Mazda Cx 9
Nov 09, 2012 | Cars & Trucks
Engage the parking break and remove the keys from the ignition before attempting any repairs. Make sure you've turned the headlight switch to the off position.
Open the hood by first pulling the interior hood release lever located below the steering wheel under the instrument panel. Then, walk around to the front of the pickup and push up on the safety catch located in the opening beneath the center of the grill. Lift the hood and secure it.
Unscrew the expanding fastener from the headlight welt, if equipped. Use a screwdriver to remove the three screws that hold it in place. However, not all Dodge Rams of this generation have this feature.
Remove the first two bolts from the headlight assembly using a socket wrench. These two bolts will be on the inside near the grille.
Remove the third bolt located on the outside bottom of the headlight assembly near the fender. You may find it easier to access this bolt from the fender well where you'll find an access hole after removing the fender plug. Use a socket wrench with a ratchet extender for easier removal.
Pull the headlight assembly away from the front of the pickup, giving special force to the fender side. Be careful not to scratch the paint or jostle the assembly too much. You don't want to have to readjust your headlight aim when you're done.
Disconnect the electrical connector by giving it a quarter-turn and pulling it straight out from the base of the bulb housing. This should remove it completely from the housing, so you can access the bulb.
Twist the collar on the headlight bulb a quarter-turn to remove it from the bulb base.
Install the new bulb into the bulb assembly, reconnect the electrical connector and place it back into the headlight housing. Replace the headlight assembly in reverse order of removal. Make sure all bolts are secure before closing the hood.
Turn on your Dodge Ram and make sure the headlights are working.
Feb 16, 2011 | 2008 Dodge Ram 2500
Jan 19, 2011 | 2008 Ford Focus SE Sedan
Mar 27, 2010 | 2008 Chevrolet Malibu
Feb 26, 2010 | 2006 Chevrolet Cobalt
Sep 05, 2009 | 2008 Chevrolet Cobalt
Apr 01, 2009 | 2008 Chevrolet Silverado 1500
Jan 10, 2009 | 2005 Chevrolet Equinox
Oct 11, 2008 | 2008 Chevrolet Suburban
632 people viewed this question
Usually answered in minutes!