Question about Chevrolet Blazer

1 Answer

How do you remove the front left axel on a 2004 Chev Blazer

Posted by on

  • theshawvers Apr 27, 2010

    The solution you gave was very helpful
    thank you

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,
First break the axle nut free, but do not take it off (to loosen/remove axle nut may require you to unstake the nut using a screwdriver and hammer). Then loosen the lugnuts. Raise and support the vehicle. Remove the wheel and tire. Now remove the axle nut. Remove the brake caliper and support up by the top of the strut (you will most likely need to remove some of the bolts holding the brake lines. DO NOT let the caliper dangle from the brake line). Remove the caliper guide. On the bottom of your strut you will see a yoke (upside down horseshoe looking thing), remove that. Now break the lower ball joint free. There will be a torsion rod running from under the radiator to here. Remove those two bolts. The spindle assembly should now pull forward and swing towards the back of the car. Now climb underneath the car. Place a prybar between the inner cv joint and the transmission and carefully pry the axle out. Yu have to be carefull ,otherwise fluid will come out.
Let us know if you want something else please accept the solution.
Thank You for contacting fixya.com

Posted on Apr 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove front left drive axel 2004 cadalic deville


front left is the drivers side. remove the wheel, remove the axle nut, disconnect and separate the ball joint, remove the axle from the spindle then pull the axle out of the transmission, you will loose some transmission fluid.

Feb 01, 2015 | 2004 Cadillac Deville

1 Answer

Remove the oil pan on a 1999 4x4 blazer do i have to remove the moter?


Either the remove the motor or remove the front axel assembly. Either way is a long job. I advise you to secure a repair manual to help giude you along.

Apr 10, 2011 | 1997 Chevrolet Blazer

3 Answers

How to replace a front wheel hub assembly on a 1999 blazer 2wd


remove tire
remove axle nut
remove 3 bolts holding hub in
sometimes may need to hit hub with hammer after all bolts out to get it to release

Dec 22, 2010 | 1999 Chevrolet Blazer

1 Answer

My 1985 chev blazer will not engage the front drive axel. I had the transmission replaced and i now have unconnected vaccume lines around transfer case/transmission area. Is there a valve or something...


if the light for 4wd does not come on it could be that a vacume line has cracked or become seperated from the ball under your battery listen under hood for a hiss, my hisses usually come from somewhere around the heater box where the lines join together on the way to the ball or the vacume ball may be bad the front wheels will not enguage without vacume applied as vacume pulls the locks in. The xfer case is working if it turns the short driveshaft

Nov 08, 2010 | 1985 Chevrolet S-10 Blazer

1 Answer

How do I remove the factory radio on a Chev.Blazer


yes the whole front dash pulls of a few small screws and some clips thats it

Jul 29, 2010 | 2000 Chevrolet Blazer

1 Answer

98 Blazer 4WD front axel falling out of differential


I would dismantle the axle, fit new thrust bearings and anything else that is worn/damaged and reassemble/adjust clearance gaps to it, according to the service manual.

Mar 12, 2017 | 1998 Chevrolet Blazer

1 Answer

How to remove a differential side axel from a 1961 Chev Belair.


remove wheels brake drum - remove cover-remove differential pinion shaft lock screw/bolt and pinion shaft -with someone helping or yourself push in axle shaft towards center and remove "C" lock do same for other side be careful not to damage seal when pulling out shafts

Mar 05, 2010 | Chevrolet Classic Cars & Trucks

1 Answer

Need to replace front left cv axel


Best approach is to acquire a repair manual for that vehicle. Pep Boys or similar will likely have one..

Apr 28, 2009 | 2004 Kia Optima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...