Question about 2002 Chevrolet Impala
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The RAP circuit breaker is directly behind the left side fuse panel. The
chevy dealer acts like its a big secret and wants 75.00 to plug it in.
You have to reach up under the dash and plug it in the BACK side of the
left fuse panel. The diagram on the plastic cover is misleading. If you
put the seat all the way back, you will have to lay on your back and
with a flashlight you should look and you will see where it plugs in.
This is on a 2002 chevy impala. Hope this helps.
Best Regards Jeff
Posted on May 03, 2011
Tips for a great answer:
Jan 31, 2017 | 2006 Chevrolet Impala
Passenger Door Switch (PDS)
Body Control Module (BCM)
Rear door power window switches
Power window motors in each of the doors
PWR WDO Circuit Breaker
Power Window System Controls
The power window system will operate anytime the Retained Accessory Power (RAP) system is active or when the ignition switch is in the ACCY or ON position.
The driver master control switches are integrated into the DDS. When a power window switch is activated in the up or down positions the DDS supplies power and ground to the window motor control circuits to drive the window motor in the required direction. Prior to activating a power window motor the DDS will supply the control circuit with a low current bias voltage in order to determine that a short to ground condition does not exist and during window motor operation the DDS continues to monitor the motor current to verify proper window motor operation.
The DDS controls the passenger window by a serial message to the PDS. When a power window switch is activated in the up or down positions the PDS supplies power and ground to the window motor control circuits to drive the window motor in the required direction. Prior to activating a power window motor the PDS will supply the control circuit with a low current bias voltage in order to determine that a short to ground condition does not exist, and during window motor operation the PDS continues to monitor the motor current to verify proper window motor operation. (Scan tool support is available for this system
Check this circuit breaker
RETAINED ACCSRY PRW BRKR 30 amp. located in the left instrument panel fuse box . if the breaker is good check power B+ at the drivers door switch . connector 1 terminal b yellow wire . Sometimes the wires inside the rubber boot coming from body to door break .
Oct 29, 2015 | 2005 Chevrolet Impala
Feb 27, 2015 | 2002 Chevrolet Impala
Aug 24, 2014 | 2004 Chevrolet Impala
May 27, 2012 | 2004 Chevrolet Impala
Jun 26, 2011 | 2005 Chevrolet Impala
Oct 18, 2010 | 2002 Chevrolet Impala
Jul 10, 2010 | 2000 Chevrolet Blazer
Nov 24, 2009 | 2003 Ford Explorer
Mar 25, 2009 | 2002 Chevrolet Impala
298 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: