Question about 1997 Ford Expedition

Open Question

Where is the brake light fuse on a 1997 ford expedition

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

warlock61
  • 659 Answers

SOURCE: FORD BRAKE LIGHT

check the connector at the brake switch located on the brake pedal lever arm if it is ok it is most likely a faulty switch

Posted on Dec 02, 2008

chuck943
  • 783 Answers

SOURCE: ford expedition yr'00 headlight not working checked fuses..

The low beam headlamps have a seperate fuse for each lamp in the central or underdash fuse panel.
The right headlamp is fuse fuse 26 (10amp) and the left is fuse 28 (10 amp). These fuse are hot only when headlamps are on so you need to test them with a test light with headlamps on. If they do not have power to them then concern is either headlamp switch or daytime running lamp relay if your vehicle is equipped with this feature, or a bad multifunction switch.
Power leaves the headlamp switch on the RD/YE wire and goes to multifunction switch. It leaves multifunction switch on the other RD/YE wire The wire will then go thru either a connector c2003 located behind the passenger side air bag behind the dash or to the DRL relay if your vehicle has this feature and leaves there on RD/BK wire to the headlights .

Posted on Feb 24, 2009

sergiososa63
  • 25 Answers

SOURCE: 1997 Ford Expedition - cruise control won't work.

Vehicles involved in the recall include the following:

1998-2002 Ford Ranger
1992-1997 Lincoln Town Car
1992-1997 Ford Expedition
1992-1997 Mercury Grand Marquis
1993-1998 Lincoln Mark VIII
1993-1995 Taurus SHO
1999-2001 Ford Explorer
1999-2001 Mercury Mountaineer
2001-2002 Ford Explorer Sport
2001-2002 Ford Explorer Sport Trac
1992-1993 E150-350 Vans
1997-2002 E150-350 vans
1993 Ford F-Series pickups
1993 Ford Bronco
1994 Mercury Capri
2003-2004 Ford F0150 Lightning
1995-2002 Ford F53 motor homes.

Posted on May 15, 2009

junmag
  • 175 Answers

SOURCE: brake light issue.

the brake lights switch of the expedition is connected to the cruise control system. get yourself a wiring diagram and sort out the problem. i have read of fires being caused by that problem so be carefull.

Posted on May 28, 2009

Gozer
  • 435 Answers

SOURCE: fuse box lay out for 1997 ford expedition with a

Go to this free Ford website to view or download the owners manual for your vehicle. The fuse block diagram is in the roadside emergency section.

https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Posted on Oct 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for brake lights on 97 Ford expedition


looks like its inside the expedition, could be near the left side above the brake pedal, OR, could be on the far left side of the between the door and the dashboard (left side being drivers side) hope it helps. IF its not the fuse, i attached a link to a youtube video that may be beneficial.

26275225-vyvzcdzr4h2s1fd111z5ju0i-2-0.gif
Brakelight switch testing and replacement Overview Ford Expedition 2004...

Sep 05, 2016 | 1997 Ford Expedition

1 Answer

97 ford expedition keeps cutting off whe I press the break


Check all your fuses and look around the brakes. Also get everything with the ignition and brakes. If you doing feel safe with that, call an mechanic to come over to and check it out.

May 02, 2014 | 1997 Ford Expedition

1 Answer

How replaced brake ligth switch on ford expedition 2003


make sure check brake light fuse first if brake light fuse okay.you replace brake light switch by removing trim panel below steering column.look under brake pedal area unplug electrical connector .remove the cotter pin and pull switch and power brake booster pushrod off the pin.then slide switch off power brake booster pushrod dont lose small nylon washer when installing new brake light switch.

Nov 13, 2011 | 2003 Ford Expedition

1 Answer

Trailer plug does not have juice to it.......1997 ford expedition


Hi,
These plugs are usually hard wired into the rear lighting - Brake lights,Tail lights, indicators etc. You need to check the earth/ground wire also.
Trace the wiring and make sure there are no breaks in the wiring from the trailer plug.
Hope this helps.

Jul 25, 2011 | 1997 Ford Expedition

1 Answer

The gear shifter is stuck in park and the brake lights do not come on in my 1997 ford expedition.


the reason the shifter is stuck in park is because the brake lights dont work.check ALL fuses if fuses ok then check brake light switch

Mar 28, 2010 | 1997 Ford Expedition

1 Answer

1997 Ford Expedition stuck in park.


There is a solenoid that requires that you have your foot on the brake with the ignition on for it to come out of park. With the key on, listen for a click coming from under the dash when you step on the brake. If you hear nothing, this is the area of the problem. It could be a fuse, a brake light switch, a bad solenoid, or??

Feb 26, 2010 | 1999 Ford Expedition

1 Answer

Turn signal and brake lights


these vehicles have a fuse for front and back turn signals. Check the owners manual where your back tail light fuses are located. It happened in my 99 expedition four yrs ago

Jun 22, 2009 | 1997 Ford Expedition

1 Answer

I don't have any tail lights brake lights, and turn signals. i dont know what fuse or relay to check or replace, because I dont have a owners manual to cross reference. Oh my vehicle is a 1997 ford...


CHECK ALL LIGHT BULBS IN THE BACK. PROBABLY HAVE A FEW BAD BULBS THAT ARE BURNT OUT COMPLETELY. CHECK LICENSE PLATE LIGHTS ALSO. CHECK FUSES TOO TO MAKE SURE THE TAIL LIGHT FUSE IS GOOD.

Jun 10, 2009 | 1997 Ford Expedition

2 Answers

Fuse box wiring 97 ford expedition


Brake sensor? Where is it located? Is it screwed in to the master cylinder?

May 04, 2009 | 1997 Ford Expedition

Not finding what you are looking for?
1997 Ford Expedition Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...