Question about 2000 Subaru Forester

Open Question

Cruise control not working 2000 subaru forester

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 83 Answers

SOURCE: 2000 grand marquis cruise control not working

Have seen this problem before. You need to look under dash at brake pedal and find a blue switch with plunger contacting pedal, disconnect connector and jump with a peice of wire and drive to see if cruise works and if it does replace deactivation switch this should get you going.

Posted on Aug 26, 2009

  • 119 Answers

SOURCE: subaru forester heater

take back to the dealer,hopefully the will find that the blend door cable is off or not adjusted properly

Posted on Jul 14, 2009

  • 119 Answers

SOURCE: Procedure for replacing rear wheel bearings 2000 Forester

i'm assuming you don't have a hubshark,this is a tool that will alllow you to remove the bearing while the knuckle is attached to the car,you may be able to rent this tool at a auto prts store .if not you need to remove the entie knuckle,first remove the trailing arm bolt,then the lateral link bolt{long and stubborn bolt},disassemble the brake shoes and parking brake cable,abs sensor if equipped the knuckle to strut bolt{no marking necessary they are not eccentric} then you need a to use or borrow a press to remove hub and bearings good luck

Posted on Jul 26, 2009

planet-x
  • 232 Answers

SOURCE: My Subaru Forester engine light and cruise control

could be transmission fault, connect the 2 loose black plugs together under the drivers side dash, turn on ignition, no start, the ecl will flash the code, slow flashes are 10's and fast ones are 1's. codes can be got from bba-reman.com

Posted on Jan 13, 2010

  • 10 Answers

SOURCE: 2000 subaru forester ignition coil wiring

Are there any other possible problems, or you are just not receiving spark at all now?

The coilpack could be dead and just need replaced. If you have a voltmeter or a test light, check the wiring on both sides of the coilpack harness to make sure it is receiving power.
I don't believe Subaru used ignitors past '99, but if they did, your should be located on the firewall behind the throttle body. Make sure it's plugged in and receiving power.

Coil packs do go bad from time to time. I had to replace mine in my
'98 Impreza a while back.

Goodluck!

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 subaru forester the cruise control indacator light stays on and i can not shut it off


is the Check Engine Light on? many newer cars will illuminate several lights and disable systems if the ECU records a DTC.

May 29, 2016 | 2005 Subaru Forester 2.5

1 Answer

Engine malfuction light comes on and cruise control light flashes


Same as the last time you got a MIL lamp on any vehicle

Check for codes,look them up & diagnose the system that
set the codes & then component test

May 03, 2014 | 2005 Subaru Forester

1 Answer

Check engine light on and cruise control light is flashing


cruise light flashing, no cruise engine light on. spent $80 for diagnoses of PO 456 but not able to fix it. No dealer within 100 miles. Not good.
Must fix myself or autozone can do it. maybe.

Dec 16, 2011 | 2006 Subaru Forester

1 Answer

2006 subaru forester,check engine light is on and cruise light is flashing, diagnoses code P0026


Possible causes are:-
- Dirty engine oil
- Low engine oil level
- Intake valve control solenoid circuit open or shorted
- Intake valve control solenoid circuit poor electrical connection
- Faulty intake valve control solenoid

May 02, 2011 | 2007 Subaru Forester Sports 2.5XT

1 Answer

MY 2004 SUBARU FORESTER XT CRUISE LIGHT KEEPS FLASHING AND CHECK ENGINE LIGHT COMES ON AT THE SAME TIME


if te check engine light is on the cruise wont work it just flashes if you erase check engine light and cruise still flashes hit cruise button twice it will go out but if engine kicks the check engine light it will flash again you have to fix what ever it is that kicks check engine light or you just deal with it

Mar 17, 2010 | 2004 Subaru Forester

1 Answer

Engine Light on Steady, Cruise control light on Strobing. All fuses OK, Gas cap OK. Cruise Control Button not working. Forrester XT 2004. What could be the problem?


check engine light has to be off for cruise to work thats how they made the car i dont like that but thats how it is

Jan 31, 2010 | 2004 Subaru Forester

2 Answers

Gas pedal on 2005 subaru forester got stuck in a


No there has not been complaint's like with the Toyota's. Toyota is involved with Subaru on a few thing's , But toyota uses Subaru technology not the other way around. And the accelerator style levers are different from Subaru's. Sorry to hear about your accident. Have a great day.

Jan 31, 2010 | 2005 Subaru Forester

1 Answer

My Subaru Forester engine light and cruise control


could be transmission fault, connect the 2 loose black plugs together under the drivers side dash, turn on ignition, no start, the ecl will flash the code, slow flashes are 10's and fast ones are 1's. codes can be got from bba-reman.com

Dec 29, 2009 | 2006 Subaru Legacy

1 Answer

My 2004 Subaru Forester has a cruise control problem. When you push the switch, the cruise control system doesn't engage. However, it can come on unexpectedly when driving. Any help will be appreciated ....


It might be a malfunction of the switch combination unit as according to your description it could be one of the internal contacts staying on all the times and this is why you have to cut the power off to cancel it. Best solution is to bring it to your local dealership or a very good electrician.
Hope it works for you and let us know what is the outcome.
Cheers.

Mar 21, 2009 | 1998 Subaru Forester

Not finding what you are looking for?
2000 Subaru Forester Logo

Related Topics:

534 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7727 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...