Question about 2002 GMC Sierra 1500

1 Answer

Shifting Problems Hi Folks, My 2001 Yukon XL SLT will start out from a dead stop in first gear and then shift into second gear normally. Between second and third gear when it tries to shift into third gear it revs like it has gone into neutral. When I let off the gas pedal and the RPM starts to decline it shifts into third gear. It will not shift into the over-drive or fouth gear at all. Reverse gear has no issues. Any Ideas??

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 79 Answers

When has the last time you had a trans serv. done on it? if you take it to a shop the will tell you that you need a rebuild. thrid gear and over drive are about burned up.

Posted on Apr 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 GMC yukon xl slt transfer case drops out of 2 wheel hi but will work in auto 4 wheel


There is a transfer case control computer in the dash on the left side around the headlight control,they will cause the blinking lights and not shifting.

Mar 30, 2014 | 2005 GMC Yukon XL

1 Answer

Gear shift light is out and Speedometer light is fading out on my 2005 yukon SLT


Sounds like your bulbs are bad. Doesnt sound like a fuse or your whole dash lights would be out.

Mar 22, 2013 | 2002 GMC Yukon XL

1 Answer

Shifting into higher gear problems with 2004 yukon xl


The shift solenoids may not be getting the correct signals from the transmission control module . Read the codes to see if it's the solenoids or the module.

Sep 03, 2017 | 2010 GMC Yukon XL

1 Answer

2004 yukon xl


Both are possible but from your description it sounds like the truck is in limp home mode. You need to put a scanner on it and see if any codes are set. Then repair the code and reset it then see what happens.

May 28, 2017 | 2010 GMC Yukon XL

1 Answer

My 2001 dakota trans slips when shifting into 3rd gear


check fluid levels and condition of fluid, look for contaminants in it, change fluid and filter if anything is seen in the fluid..also check detent cable adjustment..may be hanging up at throttle linkage..or cruise control

Feb 09, 2013 | Cars & Trucks

1 Answer

Tow/haul not working on gmc yukon 2001


The wires are probably broken. They follow the shifter down into the steering column. After many years of shifting the wires break. You can find the wires inside the rubber piece that surrounds the gear shifter. They're orange. You can splice them and put them back in.

Jul 01, 2012 | 2001 GMC Yukon XL

1 Answer

2001 GMC Yukon - Clicking noise from dash/steering column are. Starts clicking at 10mph and gets worse the faster you go. Touching the shift lever at all changes the click frequency or stops it completely...


I was having a clicking noise from a actuator under the dash of my car, it was a blend actuator.. Years ago they used cable then vacuum hose and now a lot of vehicle us actuators (motor driven gate) to open and close the vents, A/C and heater ducts. I do not know for sure that is your problem but when mine went bad I would get a clicking noise sometimes it click for a few seconds after I turned the car off. Just a thought.

Aug 02, 2017 | 2001 GMC Yukon XL

1 Answer

2001 Yukon XL SLT 4 speed Auto Transmission shift problem!


Sam,

I would start with a transmission fliud and filter service.

I would then have the trasnmission checked out by a transmission shop. The transmission most of the time has the direct drum band is starting to go. The shops can rebuild it no problem, This is a very common failure wiith the trasnmission.

Good Luck

Aug 16, 2009 | 2002 GMC Sierra 1500

1 Answer

I have a GMC Yukon XL that shifts hard 1st to 2nd gear.


sound like shift valves sticking in valve body.

Apr 26, 2009 | 2002 GMC Yukon Denali

1 Answer

2001 yukon xl 6.0 ltr engine-transmission problem


It sounds like it may be an electrical problem. Maybe a problem with the TCM, or a sensor.

Mar 09, 2009 | 2001 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...