Question about 1999 Dodge Durango

1 Answer

Looking for the location of the throttle positioner sensor in my 1999 dodge durango

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

On the driver side of the throttle body,two star screws and unplug it

Posted on Jun 06, 2010

  • 71satellite Apr 24, 2011

    make sure you disconnect your negative battery cable first

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the throttle pedal sensor located on a 2002 cheverolet silverado


There is a throttle valve positioner sensor located at the end of the throttle valve shaft on the right hand end of the shaft, the sensor then bolts to the throttle body as you face the engine from the front. A defective sensor will set the check engine light and give hesitation during acceleration.








Jun 29, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

IAIR FLOW SENSOR LOCATION 1998 DODGE DURANGO 5.9


Your vehicle is not equipped with a Mass Air Flow (MAF) sensor, but it does have a Manifold Absolute Pressure (MAP) sensor. Here is a picture of where it is located.

93_cr99duran_14-030b.png&width=560&height=467&displaytype=display&imgrotation=&links=

Sep 21, 2012 | 1999 Dodge Durango

1 Answer

Where is IAT sensor on 1999 dodge durango 5.2


Hi there:
The Idle Air Control (IAC) system consists of a stepper motor and pintle. It is mounted to the throttle body and regulates the amount of air bypassing the throttle plate.

2_22_2012_10_57_50_pm.jpg

Fig. MAP sensor, TPS and IAC motor locations-typical

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 22, 2012 | 1999 Dodge Durango

1 Answer

Where is the idle air control valve located on a 1999 dodge durango 5.9 liter engine


Its on the throttle body. Its round and has a rubber end on a spring loaded valve.

Dec 02, 2011 | 1999 Dodge Durango

1 Answer

Trying to find the crank sensor on a dodge durango 1999


To get exact procedure , please click on the link below and follow the procedure:--- http://technoanswers.blogspot.com/2011/06/where-is-crank-sensor-located-on-dodge.html ------------ This should help.Thanks.Helpmech.

Jun 02, 2011 | 1999 Dodge Durango

1 Answer

My 1999 dodge durango starts but will not keep running, what will cause this


Well if the Durango starts and runs for like 15 mins and quits then won't start again untill it has cooled off a bit I would be checking the crank sensor and the pick up coil. If it starts then dies right away but will run if you hold the gas I would clean the throttle body with carb cleaner and make sure to clean around the butterfly edges inside the throttle body.

Nov 03, 2010 | 1999 Dodge Durango

1 Answer

How do I replace the throttle pedal position on 2001 Durango


TPS is located on the side of the thottle body, and is secured by three torx screws.
Removing the air hat on top allows better access.

AZ has the part for ~$40 or so. TPS 333 if I recall correctly.

May 19, 2010 | 1999 Dodge Durango

1 Answer

The 5.9L engine runs but will not Idle.


could be the idle air control valve, vacuum leak or a bad throttle position sensor.

Mar 06, 2010 | 1999 Dodge Durango

1 Answer

1999 dodge durango will not start


sensor on backside of throttle body two hex screws gently remove as you can break brass fitting spray with throttle body cleaner till it comes clean open throttle all the way spray butterflies till they are clean imediately drive five miles as it takes ecu that far to relearn sensor five miles no less

Jan 17, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...