Question about 1993 Volkswagen Fox

Open Question

The dasboard clocks on my 2000 vw lupo 1.0 keep resetting and show no millage! do the clocks need replacing or is there a reset. the car has done approx 90K and was serviced today 27/4/2010

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: MY VW LUPO IS HUNTING

The hunting and clicking is caused by a stuck vapor canister purge valve. The valve is on a vacume line. When it gets stuck open too much air enters the engine at idle or low rpm. This will cause the engine to hunt and stall as soon as any load is put on it if you do not rev it hard. The engine will over-run when coming to a stop and probably stall. It can come and go putting the chack light on. The quick fix is to just un-plug the solenoid. facing the enginebay it is located on the left hand side just infront of the suspention mount it is half balck half blue on every lupo i have seen. unpluging it will mean the car is driveable again but the check light does come on. It is 100% safe as long as nothing else happens that goes undetected because the light is already on. The part is about £70/80 from VW,  they may or may not know what you are talking about but i would not bother going to VW. The part is easy to find at a scrapyards if there are Lupos / Polos.  A number of other VAG cars share the part as well.  Any other problems come along to clublupo.co.uk 

Posted on Jan 06, 2009

Ad
  • 11 Answers

SOURCE: 2006 vw jetta tdi service engine light reset

With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.

Posted on May 30, 2009

  • 10 Answers

SOURCE: i need to reset my service now light for my vw passat 2007

With the ignition off hold the wrench button down.
While still holding the wrench button turn on the ignition all the way, but do not start the car.

Release the wrench button and press and hold the minutes (min) for a few seconds.

You can also use a VAGCOM cable

Posted on Jul 31, 2009

  • 1 Answer

SOURCE: MY VW LUPO IS HUNTING

what does the gps light mean when it comes on ?
vw lupo

Posted on Aug 30, 2009

  • 1 Answer

SOURCE: How do you reset the service computer display on passat

volks wagon passat engine computer reboot where to plug the device into

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 vw golf 2.0, clock keep resetting after I start the car..


this can be caused be low voltage from the battery or a highdraw from the starter or a defective clcok.

Mar 26, 2010 | 2000 Volkswagen Jetta TDI

1 Answer

How do reset emission light on vw golf 1.4 petrol


If you mean the service light here is the procedure.
Button #1 mileage reset button
Button #2 Clock adjustment button

  • Switch ignition off
  • Press and hold button #1 at bottom left of speedometer
  • Switch ignition on and release button
  • The text "service Oil or service INSP" will appear in the display window. On 2000 m, y, cars the message "SERVICE NOW" will appear in the instrument cluster with center display
  • Turn button # 2 at lower side of tachometer to the right
  • The service display shown in the display window is now reset and "service _ _ _" will appear in the display window
  • Switch ignition off, service display is now set until next scheduled service interval is reached.

Mar 25, 2010 | 2000 Volkswagen Golf

1 Answer

Hi, how much would it cost to reset airbag light on my vw lupo


Sorry but that can only be answered by a repair garage. The answer depends upon:-

  • the country you're in;
  • whether you use an independent garage or a franchised outlet; and
  • the exact reason that the light has come on
The last point is really important: you may just have a loose wiring connector or the light could be telling you that an airbag has actually failed and needs replacing. It's important to note that this is not really a DIY job: if you don't understand what you're doing there's a risk of airbag detonation which could harm you and cause a lot of interior damage.

As your car is now 10 years old, it's likely that the light has just come on to tell you that the airbags have reached the end of their certified lifespan and need servicing. In practice what usually happens is that a VW garage or an airbag specialist will run diagnostics on the system and then re-certify the system for around another 5 years, resetting the airbag light to match. They can do this based on ongoing research by the airbag manufacturer using samples of airbags manufactured at the same time as yours. Many car insurers will refuse to pay out if the airbag light is ignored or if it has been reset by unqualified personnel.

The cost of the diagnostics and recertification is usually fairly low as it normally doesn't take long if all proves to be fine, but you can usually get it done for free if you get the same garage to do a major service or similar major work done at the same time, such as a cambelt replacement which will definitely be overdue if not already carried out.


Mar 19, 2010 | 2000 Volkswagen Golf

3 Answers

How do i switch off service now light on my vw golf 53 plate


Courtesy www.synthetic-direct.ca:

To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button “A” located below the speedometer. Turn off the ignition while holding the button. “OEL” will display on the indicator. Press and hold the lower digital clock reset button or the analog clock reset button “B” until five dashes appear in the display.
If needed, next press the odometer reset button until IN 01 is displayed and then press the clock reset button until five dashes appear. If needed, next press the odometer reset button until IN 02 is displayed and then press the clock reset button until five dashes appear.
To exit reset mode, turn ignition switch on and when IN 01 appears, turn ignition off.



Jul 24, 2009 | Volkswagen Golf Cars & Trucks

4 Answers

Reset the service light on a vw touran 2005


Look in owners manual you can do this yourself very easily using ignition,milage reset button and clock reset button it's in the book cant remember which page

May 30, 2009 | 2005 Volkswagen Touareg

1 Answer

1999 VW Beetle outside temp display not working


For general awareness, the outside air temperature sensor is located above the inside mirror.
Try to reset the temperature measurement unit: 1. Switch engine on. 2. Press and hold clock minute (min) and hour (h) buttons simultaneoutly longer than 3 seconds. The display will show new temperature measurement unit. 

Apr 03, 2009 | 2000 Volkswagen Beetle

1 Answer

How to i turn off the service now light on a 03 vw golf


To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.



1. Switch ignition ON.
2. Press and hold odometer reset button below speedometer.
3. Switch ignition OFF and release odometer reset button. OEL will now
display.
4. Press and hold the lower digital clock set button or the analog clock set
button until five dashes (-----) appear in display.
5. If necessary, pree odometer reset button to proceed to the IN 01 display
(15,000 mile maintenence) and reset using the clock button.
6. If necessary, repeat procedure to reset IN 02 (30,000 mile maintenence)
display.
7. To end reset mode: switch ignition ON; when display IN 01 appears, switch ignition OFF.

Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Mar 19, 2009 | 2000 Volkswagen Golf

1 Answer

Radio no turning on


fuse is bad. check the radio fuse it will be hot all the time,

Feb 01, 2009 | 2000 Volkswagen Golf

1 Answer

Can't reset electronic data


To change the clock between 12 and 24 hour display with the key off press and hold the hour and minute button at the same time for approx. 3 seconds or until the display changes.

Tp change the temp for C to F do the same thing with the key on.

Dec 08, 2008 | 2000 Volkswagen Beetle

Not finding what you are looking for?
1993 Volkswagen Fox Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...