Question about 2001 Chrysler Sebring

Open Question

Check Engine Light P0300 for 2001 Chrysler Sebring - 3.0L 6cyl. Replaced transmission a little over a month ago when it went out. Last year replaced both oxygen sensors, spark plugs and wiring harness, hoses, and timing belt. Any solutions for this new code?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: P0302 Engine Code

Acroding to the codes it is a # 2 cylinder miss fire , sounds to me like there is a lot of carbon build up

Posted on Dec 06, 2008

polarcycle
  • 1392 Answers

SOURCE: 1999 chrysler sebring, transmission doesnt shift

find out why the light is on and fix it. This will most likely be a trans wiring issue that the light is on for.

Posted on Jul 11, 2009

ZJLimited
  • 17970 Answers

SOURCE: how many oxygen sensors in a 2001 chrysler sebring

17c3292.jpg

Fig. Heated Oxygen (HO2S) location (sensor 1)-2.4L engine

db6f426.jpg

Fig. Heated Oxygen (HO2S) location (sensor 2)-2.4L engine

99e413c.jpg

Fig. Heated Oxygen (HO2S) location (bank 1, sensor 2) (bank 2, sensor 2)-2.7L engine

e2a250f.jpg

Fig. Heated Oxygen (HO2S) location (bank 2, sensor 1)-2.7L engine

I hope help you with this (rated this help). Good luck.

Posted on Sep 09, 2009

wracefans24
  • 1985 Answers

SOURCE: I have a 2005 Chrysler Town & Country with

there are no codes that say replace O2 sensors,or remove converter,Thats just somebody's guessing,When it says O2 sensor that tells the mechanic to look for trouble in that area,wiring or faulty readings,And there are four O2 sensors.

Posted on Jan 20, 2010

wireguy212
  • 1627 Answers

SOURCE: fault code p0300

Any time there is a misfire condition in an engine the o2 code will pop up,so you need to correct the misfire and that code will go away.To repair the misfire i would first try a new spark plug and then the coil for that plug.It could also be a faulty injector on that cylinder but that is not common,go with the plug first.note;all the plugs are the same age so if this is your problem,replace the rest also.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check Engine Light


have you ever changed the plugs,wires, rotor, distributor cap?it just may need a tune up. check under the cap for any signs of electrical corrosion or cracks or moisture, when was the last time the engine oil was changed? sludge in a engine will also trigger codes which will give you a check engine light even something as simple as a loose gas cap or a worn gasket on the gas cap will trigger a code

Jan 02, 2012 | Chrysler Sebring Cars & Trucks

1 Answer

My 2000 Chrysler Sebring stops running. After a few minutes it will start again and run fine. This situation just started happenning a few months ago and is increasing in frequency


is the check engine light on??
i've done a few that had no light/codes.the most common problems are crank or cam sensor failures. really need to check when car stalls.
replacing crank sensor 6 mths ago & car has'nt had a problem. if you search these sensor on the sebring you'll find alot of info.

Jul 12, 2011 | 2000 Chrysler Sebring

1 Answer

I've owned our 99 Grand Caravan for 3 years and for 3 years occasionally all instruments would quit and I would pound on the dash and it would come back. About 2 years ago the abs quit and the abs light...


the most common is a bad cluster
you have to remove it
that could be a pain but it can be done
after removing the cluster remove the cardboard cover in the back remove circuit panel board and check in the middle for a broken weld here your question for your insterment panel
The Transmission Control Module (TCM) is not communicaring with the PCM.
Check all fuses. It could be a power or ground problem or a ccd bus communication wiring problem.
If not it's likely an internal failure in the TCM.
You may be able to get a schamatic at your local library.
If it's not a power, ground or wiring issue you should take it to a dealer with a DRB III to confirm the diagnosis.
Best of Luck! Source(s): Master Technician
Shop Foreman at a Dodge Chrysler jeep Dealer

Dec 05, 2010 | Dodge Grand Caravan Cars & Trucks

2 Answers

1999 chrysler sebring, transmission doesnt shift


find out why the light is on and fix it. This will most likely be a trans wiring issue that the light is on for.

Jul 11, 2009 | 2004 Chrysler Sebring

1 Answer

I bought my 2005 sebring a year ago and it is due for smog check.I put 3,000 miles on the 2.7 litre engine in the last year and it now has 36,000 miles.A couple months ago the malfunction yellow light came...


the 2.7l has a sludge problem. This could cause the stalling and loss of power. There's a few fixes, the new water pump (which is part of the problem) doesn't dump coolant into the oil pan. Easy way to check is to simply drop the oil pan.

Mar 24, 2009 | 2005 Chrysler Sebring Conv

1 Answer

2002 Chrysler Sebring


was the tranny changed by friends or the dealer. This car is picky for what fluids and mech thats done to it? Check autozone for help aswell

Dec 24, 2008 | 2002 Chrysler Sebring

1 Answer

P0302 Engine Code


Acroding to the codes it is a # 2 cylinder miss fire , sounds to me like there is a lot of carbon build up

Nov 21, 2008 | 1997 Chrysler Sebring

1 Answer

Car hesitation


had a problem with a grand prix like that once, was the fuel filter, and injectors, all needed replaced, and it only had 89,000 miles.
Would check fuel filter first. Is it possible you got some bad gas??

Jul 05, 2008 | 2004 Chrysler Sebring

Not finding what you are looking for?
2001 Chrysler Sebring Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...