Question about 2006 Mazda 5

Open Question

NONE of my Mazda 5's power windows are working. Fuses are all good. I found this similar problem on the site by bigscoob35: "I am trying to narrow down the issue that's preventing my driver's side window from going up or down. I'm not sure where the relays are located or if all 4 window relays are compatible. My thought was that if I can locate and swap the relays and my issue shows up on another window then I would know that that's the problem. Any additional suggestions?" With this solution gven by Bruce0502: "It's never the relays! nearly allways a broken wire wire in the gland where they go from the post to the door! The constant opening and closeing snaps then in time look at them you willfind one or mores napped! BEWARE LOOK CLOSELY DON'T ASSUME THEY AE O.K.JUST BECAUSE THEY LOOK IT ! Most times the do look o.k. but the copper conducter has snapped inside the pvc insulation leaving the out side of the wire looking perfect! thw way to go is to pull each one! the one (s) that are broken will just strech an snap alltogether! the healthy ones will stand the test! Trust me..I'm an Autoelectrician 35 years seen it all before! Thats you sorted then! P.S.PUT A HOLE NEW PICE IN DON'T JUST JOIN IT WHERE IT'S SNAPED! JOIN THE NEW TO THE OLD INSIDE THE DOOR AND THESAME IN THE PILLER....LEAVE EXTRA SO IT CAN MOVE ABOUT EASYER! Remember mfs try to save on wire to cut costs you are not youwant to avoid the same problem again "THEY DO NOT" Tried all that and the conductor's are all ok. What now?

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 123 Answers

SOURCE: Driver's side window will not go up/down

It's never the relays! nearly allways a broken wire wire in the gland where they go from the post to the door!

The constant opening and closeing snaps then in time look at them you willfind one or mores napped!

BEWARE LOOK CLOSELY DON'T ASSUME THEY AE O.K.JUST BECAUSE THEY LOOK IT !
Most times the do look o.k. but the copper conducter has snapped inside the pvc insulation leaving the out side of the wire looking perfect! thw way to go is to pull each one! the one (s) that are broken will just strech an snap alltogether! the healthy ones will stand the test!
Trust me..I'm an Autoelectrician 35 years seen it all before!
Thats you sorted then!
P.S.PUT A HOLE NEW PICE IN DON'T JUST JOIN IT WHERE IT'S SNAPED! JOIN THE NEW TO THE OLD INSIDE THE DOOR AND THESAME IN THE PILLER....LEAVE EXTRA SO IT CAN MOVE ABOUT EASYER!
Remember mfs try to save on wire to cut costs you are not youwant to avoid the same problem again "THEY DO NOT"
Have a great day!

Posted on Mar 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 Mazda 6 windows stopped working


Window reset. Look in your owners manual.

Aug 14, 2016 | Mazda Cars & Trucks

1 Answer

Running lights wont work, bulbs are fine.


are you sure you pushed the wire connectors fully home? the alarm probably is disarmed when key in ignition,otherwise it would trigger when you want to start vehicle.The only other thing with your lights there may be a relay for that particular circuit check in the workshop manual hope this helps

Mar 29, 2014 | 1996 Mazda Familia

1 Answer

None of the windows will work on my 2003 Toyota Camry


Check your fuse panel under the dash on the driver side and in the engine compartment. One time I had a customer with a similar problem, I checked all the fuses, they were fine. I disconnected the battery positive cable and let stand for five minutes. I turned the key on but didn't start the vehicle, I left the key on for another five minutes for the computer to boot and run diagnostics. After the five minutes were up I started the engine, the windows worked fine. I've worked on lots of Toyota and have found their electrical systems are good, but finicky.

Oct 18, 2013 | 2003 Toyota Camry

1 Answer

2000 KIA


Check the ground connections. My 2001 Sportage had same problem during the dry summer started working when it rained found a loose ground that only made contact when wet.

Jan 07, 2013 | 2000 Kia Sportage

1 Answer

No power to fuel pump, fuses and pump are good.


Check fuel pump solenoid...fuse box in engine bay.Just swap with a similar looking one from the same box to eliminat solenoid problem.If found defective replace with new one.

Sep 18, 2011 | 1985 Mazda RX-7

1 Answer

Power windows at my Mazda MPV 2000 doesn't work. Can it be just breaker ? Thanks


possible, i would check fuses first. if good, check power at switches,if good check power at window motors, if good then it would be the cable or gear mechanism. All you need is a test light and you will search and conquer your quest.

Jan 10, 2011 | 2000 Mazda MPV

1 Answer

Bought a used 93 mazda protege.(as is) A/C compressor does not start or engage.. When warmed up and running large primary fan is on. I fouund aux fan fuse removed from fuse box.under hood. I also found aux...


Sounds like u have a bad fan for 1,Im sure who disconnected it may have found an expensive problem they didn't want to deal with (electrical, ac compressor etc) Good luck, have it ckd

Apr 07, 2017 | 1993 Mazda Protege

1 Answer

All of my windows stopped working including the sunroof, none of the window switches work and I've checked all the fuses and it seems there all good??


Sounds like a relay has had it. Do a google search for window relay replacement toyota camry or something similar.

Make sure you check the fuses thoroughly, sometimes they look fine until you get it out and really closely inspect

Jul 02, 2009 | 2002 Toyota Camry

2 Answers

2006 Mazda 6 Power windows and Mirrors not working?


you can check the fuse house..for Japanese car usually in the front under the steering wheel, read the fuse type at the cover of fuse house and replace it with the right type...

Jan 01, 2009 | 2006 Mazda 3

Not finding what you are looking for?
2006 Mazda 5 Logo

Related Topics:

473 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...