Question about 1994 Ford Probe

1 Answer

We are trying to take the water pump out of my 94 ford probe but there is a plastic shield that we cant get off????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 2,984 Answers

Well, I looked at the drawings for all the motor sizes for the 94 Probe (you didn't post your engine size), and I think the plastic covers you are talking about is the timing belt covers...

we are trying to take the water pump out of my 94 - 38e48b3.gif
Exploded view of the timing cover assembly for the 1.5L and 1995 1.6L engines-1995-98 1.8L engine is similar

If this doesn't look right then please post your engine size and I can post the correct drawing for you.

Posted on Apr 27, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

What causes a 94 ford mustang not to run unless the fuel pump is straight wired to the battery, if not the fuel pump dont get fire

Not sure if that modle has it but my 94 probe did and had same prolem so try this look in the trunk for a fuel shut off switch it'll be under the carpet of either driver side or passenger side and it will have a button on it push button back in also check clip and plug on it for melted plastic hope this helps good luck

Dec 14, 2011 | 1994 Ford Mustang

1 Answer

How to change water pump on 1991 ford probe?

The water pump appears to be near the top of the engine on the passenger side of the car,you need to replace the water pump from under the car.The car has to be lifted on jackstands.
--------- For details and appropriate diagram,click this link below and get more details:--- ------------ This should help.Thanks.Helpmech.

Oct 07, 2011 | 1991 Ford Probe

1 Answer

I have a 94 ford probe 4 cylinder 2.0 liter engine could a 96 ford f150 battery fit?

take the battery out of the probe and try it, if it fits in the tray and does not hit the bottom of the hood then when you close then it fits.

Dec 15, 2010 | 1994 Ford Probe

1 Answer

My 94 ford probe is not turning on the fuel pump shut off switch in the back has been pressed it seems as though the button wont come back up and i cant figure out how to reset the button

If the button is down, that's the on position, if you tap on it with the end of a screw driver, you will hear a spring like noise, might have to do it a few time's, and the button will come up, that's the off position, with button down, check for voltage at both wire's, one will always have voltage, and the other only when button is down, if you don't have voltage at both wire's with button down, bad switch.

Sep 09, 2010 | 1994 Ford Probe

2 Answers

Dash / tail lights 94 ford probe not working

Check fuse panel for blown fuses and check trunk wiring for cut wire and check tail bulbs for blown light.

Aug 15, 2010 | 1994 Ford Probe

1 Answer

I need timing belt digrams for a 94 ford probe gt has a 6 cylindar engine

moz-screenshot-1.pngAlign the engine timing marks as follows, then install the belt.


Once the belt is routed, as shown below, install the indicated pulley last, then pull the pin out of the hydrualic-tensioner.

May 20, 2010 | 1994 Ford Probe

2 Answers

94' Ford Probe Automatic Transmission fluid check question

The car needs to be running with the transmission warm, (drive around for at least 10 minutes) Place the car in neutral. Pull the stick wipe it off and place it back in the transmission. Reads just like an oil stick, want fluid in the safe range (checked pattern) area.

May 12, 2009 | 1995 Ford Probe

2 Answers

No spark out of coil

reset fuel pump shoud b in the trunk on the side? if not that ecm

May 07, 2009 | 1993 Ford Probe

Not finding what you are looking for?
1994 Ford Probe Logo

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides