Question about 2002 Nissan Xterra

1 Answer

I have replaced the fuel pump and fuel filter checked the fuse and all is good but yet no fuel and engine wont fire

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Most likely caused by corrosion/oxidation of the terminal that connects to the fuel pump terminal. It's due to a defective plastic molding.... (It's a recall.)

Posted on May 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 TLC Gas engine...wont start


Check to ensure fuel pump fuse hasn't burned out. Try spraying starting fluid directly into the throttle body to see if it tries to catch.

Nov 16, 2013 | 1989 Toyota Land Cruiser

1 Answer

89 mitsubishi carby model has spark and pumps fuel to carby but the spark plugs are dry just keeps cranking but wont even try to fire also has good comp,was driving till water pump blew now just wont fire...


Check that the fuel pump is working and pumping fuel (fuse or burnt out) as it sounds like there is no fuel in the carby. To check if the engine is going to run remove the air filter from the top of the carby and pour about a table spoon of fuel directly into the carby throat. Replace the air filter and crank the engine. If is going to run it will fire and then stop

Feb 20, 2013 | Cars & Trucks

1 Answer

Wont start and got fire and new pump filter and sensors


check see if engine getting fuel.listen for fuel pump operation with ignition switch on, could have blowed fuel pump fuse or bad relay.fuel pump wire harness could have short.code scan for pcm fault.if you have major intake leak vechicle wont start.

Nov 08, 2011 | 1997 Chevrolet Astro

1 Answer

Why drivering, truck stop,wont restart . what to look for


the usual would be check fuel pump/fuel filter [no fuel pressure try spray starter fluid if fires up -u have fuel problem-turn key on listen for hum of pump no hum check fuses and wiring /connectors -if hum check fuel pressure to throttle body if no pressure turn off and test pressure before filter if good replace filter if no replace pump and retest-if u had an electronic /sensor problem would show up as a check engine light

Jun 15, 2010 | 2000 Chevrolet S-10

1 Answer

Engine turning over and firing but wont start. timing chain looks good, has new crank sensor, o2 sensors, and cat.


check wiring, fuses and relay for fuel pump and check fuel filter---also recheck to crank sensor wiring ,connections and sensor new doesnt mean not defective

Feb 10, 2010 | Chevrolet Blazer Cars & Trucks

2 Answers

Injecters wont spray everything else is working fuel pump module what else is there


Check all of your fuses....and double check your fuel pump pressure..with a guage..to get atleast 3 readings...and if that is good, check the pressure after it goes through the fuel filter, to see if the pressure is still good..if not, replace the fuel filter

Nov 27, 2009 | Chevrolet 1500 Cars & Trucks

1 Answer

Wont start , no fuel getting to fuel pump


Are you sure there is gas in the tank? I "fixed" more than one car that came in for a fuel pump replacement that ran out of gas. If you have gas, check the fuel pump fuse, fuel pump relay, check for power to the fuel pump. check wiring, kinked lines, clogged fuel filter. Sometimes new FI cars are hard to prime if there is air in the system. Take off the air filter and have someone squirt fuel down the throttle body while you crank the engine. If it fires, you know it's not getting fuel, but when it does fire , it may prime the pump enough to run.

Jun 29, 2009 | 1991 Toyota MR2

3 Answers

1986 BMW 318i;Turns over but engine wont run.I'm


Fuel pump may be getting weak. If pressure is not high enough the injectors wont open.

Jun 27, 2009 | 1986 BMW 3 Series

1 Answer

97 buick skylark wont start


if starter fluid made it chug, I would suspect fuel pump fuse, relay or pump, also fuel filter.

Dec 29, 2008 | 1997 Buick Skylark

Not finding what you are looking for?
2002 Nissan Xterra Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...