Question about 2002 Chevrolet Impala

1 Answer

Car wouldn't move

I was sitting at the red light and about to pull off when my car wouldn't go, and so i cut the car off and back on and then it went with no problem, what is the problem, please help

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Your car has an AT it has a computer to tell it what to do most cars and trucks with AT have what called safe mode so if the transmission gets to hot or something like that it will stop working until the car is turned off is the check engine light on???

Posted on Apr 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 dodge intrepid 3.7 liter. Check engine light came on, RPM's went up and down, car made a weird noise. I pulled over to the side of the road and shut the car off. It wouldn't restart. It w


Whatever happened, the engine computer sensed it and turned on the light. You will have to have the computer scanned for the trouble codes- a tech or mechanic could then follow the codes to find the problem.

Jun 08, 2013 | Cars & Trucks

1 Answer

Pontiac g6 drive the car a bit went somewhere got out came back 2 hours later all it did was turn over an wouldn't start has plenty gas left it alone for a bit try to start it it fired right up. So I...


flassed less engine power wth????????? Flashed reduced engine power ! Electronic throttle control problem ! Your best bet ,take it to a GM dealer , buick , cadillac , GMC . You do not have diagnostic test equipment or knowledge to even diagnose this.

Jul 06, 2017 | Cars & Trucks

1 Answer

My 98 Sentra does not turn over


Has the battery been load tested? do that first.

Apr 30, 2017 | 1998 Nissan Sentra

1 Answer

My 2007 dodge charger didn't crank so I jumped it


A battery from 07 is still decently new to be that bad, but I would check the alternator first, just get the car running and unhook the positive cable from the battery, if the car dies the alternator is bad.

Oct 22, 2012 | Cars & Trucks

1 Answer

HOW TO INSTALL STARTER ON A 97 FORD THUNDERBIRD


I'm not sure that your starter is in good condition .You have to pull your starter out from engine .
Ensure the safety dental starter and the engine .
If you find that the dental starter Moving north and right .
You have to replace the starter .
good luck , and let me know .............

Nov 02, 2011 | Cars & Trucks

1 Answer

Engine cut off, wouldn.t start 6.0


You need to flush your fuel system completely and get a new fuel filter.

Sep 12, 2009 | 2004 Ford F350

1 Answer

Clutch problem


Its is totally acceptable to reuse a flywheel as long as it was machined to where a new finish was achieved.A machine shop will cut off about .020"-.050" to achieve a new,machined finsih.Same concept as turning brake rotors when performing a brake job.Have the clutch hydraulics checked,as this is what applies and releases the clutch when actuating the pedal.The clutch pedal engagement point is also adjustable up under the dash.One thing to remember when driving a manual trans vehicle is,for example,when sitting at a stop light.apply the brake and sit still.I can't tell you how many times i've seen people sit at a stop light,and rock the vehicle back and forth by applying then relasing the clutch pedal,causing the vehicle to pull forward a couple feet,then roll back a couple feet,pull forward,and roll back.This severely shortens the lifespan of the clutch,as it gets TOO hot.If at a traffic light,just apply the brake and sit still.There are correct and incorrect ways to drive a manual trans vehicle,all of which is determinate of how long the clutch will last.

Aug 03, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
2002 Chevrolet Impala Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...