Question about 2008 Chrysler 300

Open Question

My 2008, Chrysler 300 shakes and hesitates when it reaches a certain speed, 70mph. It seems to be misfiring?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: Random Misfire , Code 300 on OBD Scanner .

Hi,
Thanks for the response.
I took my car to the shop and had the coil packs replaced, out of 6 coil packs were dead.

Posted on Jul 16, 2008

Ad
  • 4 Answers

SOURCE: While accelerating,the vehicle hesitate and even jerks

Hesitation,jerking,acts as if it's not getting fuel? Have the egr/coil checked! I had same problem,thought it might be injectors,after delving deeper into it,I found the coil was defective

Posted on May 13, 2009

  • 112 Answers

SOURCE: Car shaking at 60-65mph, but goes away after speeding up to 68-70mph and doesn't come back until I slow down back to 60-65.

seems like there might be something goin on with your suspension

Posted on May 27, 2009

  • 6982 Answers

SOURCE: my 1999 Buick Park Avenue shakes

One of three items is giving you this problem: 1. bad tire (broken belt etc) 2. bad wheel hub bearing 3.binding brake caliper

Posted on Jun 07, 2009

pippall
  • 1486 Answers

SOURCE: 2001 Chrysler LHS engine misfire

You have a spark plug or wire breaking down under pressure.I would have them changed.

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Has a shake in the front end shakes then stops then shakes again only at hwy speeds around 70 mph


Looseness in the front end or a tread separation in the tire. This is extreme but you get the idea if there is a bulge near the side of the tire even a tiny one
shake-in-front-end-shakes-stops-shakes-sygwlwfvwwwmhqobkeiwcpio-3-0.jpg

Jul 14, 2012 | 2006 Chrysler Pacifica Touring

1 Answer

2002 Chevy silverado, at speeds of 60+ mph, it feels like the transmission slips or it sputters(hesitates), but only at high speeds


Are you certain that it is the transmission and not the engine misfiring? I would recommend scanning your onboard computer network to BEGIN proper diagnosis.

May 20, 2012 | 2002 Chevrolet Silverado 1500

1 Answer

99 sportage engine shaking, hesitates when accelerating


use a couple of quality injector cleaner in the tank
run fault codes
remove and clean injectors
check fuel pressure

Oct 22, 2017 | Jeep Grand Cherokee Cars & Trucks

1 Answer

2008 chrysler 300 heater/ac control only changes functions when fan is on high


sounds like a electrical issue in the switchs there not flashing a trouble code are they

Nov 20, 2011 | 2008 Chrysler 300

2 Answers

Misfire


It may be that there is carbon build up. Check the bulletins for you car.

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 09-005-05, DATED
DECEMBER 2, 2005, WHICH SHOULD BE REMOVED FROM YOUR FILES. THIS IS A
COMPLETE REVISION AND NO ASTERISKS HAVE BEEN USED TO HIGHLIGHT
REVISIONS.
SUBJECT:
Multiple Cylinder Misfire Or Rough Idle
OVERVIEW:
This bulletin involves rotating all engine exhaust valves, replacing the valve spring retainer
locks with a new design to increase valve rotation at lower RPM, inspecting/replacing the
MAP sensor (as necessary), and decarbonizing the combustion chamber.
MODELS:
2004 - 2006 (CS) Pacifica
2005 - 2006 (LX) Chrysler 300/Magnum/Charger

Of course you know how much the dealer is going to be if you are out of warranty. You can try a few things which may possible help, like getting some of the mopar fuel cleaner or another good fuel cleaner, I've heard a few people resolving the issue that way. If you need a good service manual Promanuals has one relatively inexpensive.

Sep 19, 2009 | 2005 Chrysler 300

1 Answer

My 1999 Buick Park Avenue shakes


One of three items is giving you this problem: 1. bad tire (broken belt etc) 2. bad wheel hub bearing 3.binding brake caliper

Jun 07, 2009 | 1999 Buick Park Avenue

1 Answer

2003 Chrysler 300m check engine light staying on


The only way, for shure is to go to computer diagnostics. 99% sure that this is some engine sensor, buy only diagnostics will tell who. (130,000 miles, hm lamda. it have only 150,000km live)

Apr 28, 2009 | 2003 Chrysler 300M

1 Answer

Engine Misfire issues on 99 Camry


You need to take this to a dealer, I think you may have an issue with the injector circuit, possible a defective PCM or wiring issue to the injectors, I don't think that the injectors themselves are the cause.

Dec 02, 2008 | 1999 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...