Question about 1994 Chevrolet Camaro

Open Question

Wipers won't go all the way down. 1993 Z28 Camaro

My wipers only go down once in a while. Most of the time they stay
above where they are supposed to be. Any help? They just don't
go into the cradle where they are supposed to be when I shut them off.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76109 Answers

SOURCE: Timing Venture wipers

disconnect the wiper transmission from the motor, then run the motor and turn the motor off with the wiper switch, this will park the motor, re-attach the wiper trans linkage so the wipers are parked/down

Posted on Dec 05, 2008

Ad
  • 159 Answers

SOURCE: 1993 jeep cherokee country series--replace windshield wipers

Are trying to remove the blade or the arms?

The arms are released by holding the wiper blade fully extended away from the winshield and wiggle the arms off.

The blades are removed by a little tab where the blade hooks to the arm,using a small screwdriver push down on tab,and slide blade off arm but do not let arm slap windshield as it could crack it,I have seen people pull and the blades suddenly come off and the arm slaps down,yor can put a towel or cloth down where the arm sits against the windshield to prevent the possibilty of the arm slapping down.

Posted on Dec 30, 2008

  • 90 Answers

SOURCE: 1999 Chevy Venture, Windshield wipers stop in upright position

You will need to replace the wiper transmission.This is a common problem.

Posted on Jan 24, 2009

  • 10 Answers

SOURCE: Problems with tun signal/wiper arm on 2004 chevy venture mini-van

I had the same thing - it also affects the 4 way flashers.  you'll end up replacing the entire control arm (turn signal lever)
Good luck!

Posted on Apr 09, 2009

mechanicm639
  • 253 Answers

SOURCE: 1983 chevy pick up wipers won't turn off

The wipers have a control module in the wiper motor. That is what is wrong. On that model you will have to replace the wiper motor . Good Luck

Posted on May 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is wipers control module located on 1995 gran marquis


This is usually a contact inside the wiper motor. Some are accessible and some require replacing the wiper motor. The inside of the wiper motor jumps into a derailer which breaks the electric contact that keeps the motor turning. Once the motor cycles, it parks in the down position.

The insides of the wiper motor are suppose to coast without power into the Park position.

Mar 25, 2014 | 1995 Mercury Grand Marquis

1 Answer

1999 Camaro wipers will only work when washing?


ITS BUILT INTO THE WIPER MOTOR UNDER THE FRONT COWL. ITS THE LONG PLASTIC PIECE IN FRONT OF THE WINDSHIELD.

Feb 21, 2013 | 1999 Chevrolet Camaro

1 Answer

My windscreen wipers have stopped working but it was just an intermittent problem to start with and they usually started working again after a short drive. What might be the problem. I can't find the fuse...


Could be the solder cracked on the wiper circuit board. Mine did that once that was the problem.Prob. not a fuse but it should be some were around the side of the dash or maybe under dash at the steering wheel.

Aug 24, 2010 | 1995 Chevrolet Camaro

1 Answer

How to replace a wiper arm on 1998 chevy camaro Z28


i dont remember exactly on camaros, but if you dont see a nut on the wiper arm, then there is a plastic cap covering it. remove that with a screwdriver by prying off gently. and loosen the nut almost all the way off. now wiggle the wiper arm back and forth and up and down.. you might need a screw driver to pry from underneath with slight force. wiper arms are tricky. make sure you put it in the exact position you took it off from. sometimes you have to turn the wipers on and shut off the key to stop them if the hood is in the way,

Jul 18, 2010 | 1998 Chevrolet Camaro

1 Answer

Wiper blades stop in middle of windshield


have you had any recent work done near the wipers? .if no the linkage from the wipers to the motor has come out of adjustment, there is a removeable cover above hood, and below winshield to see and repair as needed.. good luck marty

May 27, 2009 | 1998 Ford F150 Regular Cab

2 Answers

Car window wipers are messed up


Take the cap covers off where the bottom of the wiper is. Lossen both bolts and adjust freely to where you want it then tighnen them up.

Jul 11, 2008 | 2000 Buick Century

Not finding what you are looking for?
1994 Chevrolet Camaro Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...