Question about 2003 Mitsubishi Galant

1 Answer

Working on a 2003 Mitsubishi Galant due to a shudder in the brake pedal at speeds over 45. It is coming from the left front and I replaced the brake pads and rotor with no real change in the shudder. Any suggestions?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 267 Answers

If you already did the brakes and rotor something else in that wheel is loose. Check for ball joints being worn out. how about wheel being out of balance maybe due to pot holes this winter? Also try this
find a place on that corner of the car where you can push down on the car to load the suspension (find somewhere that won't hurt the car like top of the shocks under the hood) while bouncing up and down watch the steering wheel. If it is moving something is damaged in the suspension. If this helps please reply
good luck

Posted on Apr 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission shudder on 1997 Mercury Gran Marquis


When you get a shutter- drag the brake pedal lightly-
that will turn off the torque converter clutch if the solenoid
is working

The rpm should go up with any brake pedal application-
if the converter is releasing

If you determine the torque converter clutch is bad & the
shutter,then the trans has to come out

Check engine & trans mounts also for wear

Jan 17, 2013 | Mercury Grand Marquis Cars & Trucks

1 Answer

Dear sir I own a mitsubishi galant sport, registered aug 02. It has only done 70000mls but for qute a long time now I've experienced severe shuddering of the engine when releasing the clutch from...


check to see if you are low on fluid in the clutch master cyclinder you probably have a slave cyclinder leaking this is why its better when you pump the pedal

Feb 09, 2011 | 2002 Mitsubishi Galant

1 Answer

My car shudders when i brake and when i go to accelerate it stops completeley , , water has been leaking recentley and no lights go on, not the oil or check engine


vibration when braking is cause by warped rotors. have rotors turned.

please localize water leak for recommendations.

if your indicator lights aren't working, check the connector in the back of the instrument panel.

Sep 22, 2010 | 2003 Mitsubishi Galant

1 Answer

2003 Mitsubishi Galant electrical problem: When you step on the brake pedal of the vehicle, the parking lights come on with the braking lights. When you have the headlight switch on the ON position all...


Check to make sure your body grounds are good at all points. Particularly from the battery to the body. If ground is good to the engine for starting it, and it runs, but the ground wire from battery to body is disconnected or dirty/corroded, then that would be your problem. There's not much as far as ground between motor and body because of rubber engine and transmission mounts. Try a jumper cable from ground to body at the clean metal of maybe the bumper. Unless of course the bumper is rubber. But test this with a jumper ground to body.

May 12, 2017 | 2003 Mitsubishi Galant

1 Answer

Braking problem


check all brake lines for breaks or tears, then check the brake master cylinder, finally if problem persists, check brake booster. Master Cylinder and Brake Booster should be mounted together on driverside against the firewall.

Mar 04, 2009 | 2008 Mitsubishi Galant

Not finding what you are looking for?
2003 Mitsubishi Galant Logo

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...