Question about 1999 Isuzu Trooper

1 Answer

I was changing my gauge faces from black to white now my gauges wont work properlyof.What can I do ?

Posted by on

  • theblackdiam Apr 26, 2010

    it was only a white stick on overlay.I didnt put on any new parts.Now the speedometer starts at 20

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

The most logical thing to me is to put the old ones back on and see if they work. If the do then you have the wrong aftermarket part.

Posted on Apr 26, 2010

  • taurus323 Apr 26, 2010

    Get a magnifying glass and make sure there is enough clearance between the needle hand and the face and the same with the needle shaft and the cutout of the new face

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed gauges and alarm wont go off


check gauges sensor location upper of the oil filter black color take it out clean it well then try it if no change it and don't worry it's cheap

Mar 14, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Temp gauge not working


Change the temp sender

Mar 01, 2014 | Cars & Trucks

3 Answers

Hello: my gas gauge is not working on my 1998 cavalier , any help any suggestions, thank you.


you should be able to find the fuel tank harness under the car near the fuel tank. If you look just in front of the rear axle on the drivers side you will see two connectors Unplug the connector with the grey, purple, black, and black/white wires.

Ground the purple wire. Turn the key to the run position. The gauge should read full. If it does you have a bad sending unit (the part in the tank that tells the gauge what the fuel level is at).

If the gauge still reads empty you have a bad gauge.

Apr 26, 2011 | 2005 Chevrolet Cavalier

1 Answer

2007 Chevy silverado (classic). Once hooked up to trailer, the brake lights do not work only turn signals on trailer.


firat of all check and make sure you have a real good ground or otherwise you will lose current to another wire and this can short out and cause the lights to malfunction.

White: Ground
Brown: Running
Yellow: LT and Stop
Green: RT and Stop

This is the wiring code for the 4 wire trailers and
Wire a round seven-pin hitch, typically sold without a wiring harness, to the vehicle observing the following color codes: Run a white 10-gauge wire between ground and terminal one, run the blue 12-gauge wire between the electric brake controller and terminal two, the brown 14-gauge wire between the taillights and terminal three, the black 10-gauge wire between the permanently live 12-volt supply and terminal four, the yellow 14-gauge wire between the left turn/brake light and terminal five, the green 14-gauge wire between the right turn/brake light and terminal six and the purple 14-gauge wire between the backup light and terminal seven (in the center).

Feb 18, 2011 | 2007 Chevrolet Silverado Classic SS New...

1 Answer

My 1969 chevelle's gas gauge is stuck pass full.bad gauge or sending unit? how to tell?


According to what I read, test the gauge first. Hook power to where the white wire attaches. Hook a ground to the black wire connector. The gauge should rise to full. (May take a while). When on full, the tan wire connector to same ground. It should go to empty. If both work, gauge is good. To test sender, in the empty position, your ohm meter should read 0-2. 1/2 tank should read about 40, and full should read 84-88 ohms.

May 17, 2010 | Cars & Trucks

1 Answer

Fuel level sensor ground crossed with fuel pump ground on a 98 chevy truck. what color are these ground wires?


i think the ground wire going to the gauge is black/white stripe and solid black is pump ground the bigger gauge wires r pump wires and the smaller gauge wires go to the fuel guage

Mar 16, 2010 | 1998 Chevrolet C1500

1 Answer

97 s10 pickup 4.3 sending unit. purple to gauge black/white wire? my black/white wire has 5v at conector sending unit does your sending unit get volts. my ohms are correct on sending unit. nothing on gauge...


Hello,
It is ok for your gauge to go to 1/4 when off. It is even some what normal. The gauge is going to its neutral position. Keep in mind it is also comon for the sending unit to fail in this year / make of vehicle.

I hope this helps.

Roy

Nov 05, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

Color code for fuel sender 1994 dodge ram 1500


dark green/ black....fuel pump power. Black...ground. Dark blue.... feed to fuel gauge black/white ground for fuel gauge.

Oct 09, 2009 | 1996 Dodge Ram 1500 Club Cab

2 Answers

I have a 1996 Toyota Tercel with an aftermarket alarm system that I'm uninstalling. There are two large gauge wires from the ignition bundle, black/yellow & white/red that have taps on them. A third...


something is obviously wrong with the wiring try reinstalling the old system and letting a n experienced mechanic install this other one for you wiring is everything

Sep 06, 2009 | 1996 Toyota Tercel

Not finding what you are looking for?
1999 Isuzu Trooper Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...