Question about 2000 Chevrolet Monte Carlo

1 Answer

I have a 2000 Chevy Monte Carlo with a 3.4l v-6. The check engine light comes on, and when it was scanned it says cylinder 1 is mis-firing. Is this a plug or wire issue, and if so, where is cylinder one located on the motor?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

Number one should be first plug passenger side front bank. if you don't want to invest in a tuneup try swapping the wire with one from another cylinder and see if the misfire moves to that new cylinder.

Posted on Apr 26, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fireing order 85 monte carlo


1-8-4-3-6-5-7-2 and no 1 cylinder is first cylinder front drivers side

May 23, 2014 | 1985 Chevrolet Monte Carlo

1 Answer

Abs light will not go off on my dashboard in my 00 chevy monte carlo


If the ABS light comes on and stays on the ABS system self check has detected a fault. Scanning the ABS system for trouble codes will help identify what the problem could be. Most often it is a bad wheel speed sensor, loose wheel bearing, or a broken wire in one of the front harnesses to the speed sensors.

Nov 02, 2013 | 2000 Chevrolet Monte Carlo

1 Answer

Cylinder one on monte carlo 2003


If the code is 301 it means there is no power from that cylinder. It could be a problem with the ignition, fuel injector, or something mechanical.

Dec 06, 2012 | 2003 Chevrolet Monte Carlo

2 Answers

My 2002 Chevy Monte Carlo ss has a miss. Rpm gauge jumps up an down while driving. Has new air filter, plugs an wires. Other suggestions?


Stop by any good parts store and have them do an OBII scan (fault scan) Most will do it FREE. They'll pull codes and identify what is causing your "miss"

Apr 30, 2011 | 2002 Chevrolet Monte Carlo

2 Answers

2001 chevy monte carlo 3.8 liter v-6: starts fine


is your check engine light on ? if not check the fuel filter it may be plugged. it is also possible that your fuel pressure is low, is it start it then it bogs and dies, for you may have a defective idle air mixture solenoid, this will not call up a code there for no check engine light, hope this helps , let me know good luck

Jan 28, 2010 | 2001 Chevrolet Monte Carlo

1 Answer

I need a diagram for the plug wires for a 97


diagram? or firing order? looking a engine from passenger fender, the cylinders on your right are 1-3-5, on your right are 2-4-6. Does this help?

Jan 15, 2010 | 1997 Chevrolet Monte Carlo

1 Answer

Firing and wires order 87 chevy 4.3


6 5
4 3
2 1
Front of engine

The distributor will have one marked; firing order is 1-6-5-4-3-2

Hope this helps,
matt

Sep 20, 2009 | 1987 Chevrolet Monte Carlo

1 Answer

How do you know which spark plug is which? on a


u need to get the rite plug wires on da rite plugs-be careful hi volts-without a repair manual just swap them until shakin stops-dont think coils r bad-which ones do u think r connected normally n go from there

Aug 31, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

PO171


P0171 - Fuel Trim System Lean Bank 1
YOU WILL NEED TO AVE THE DEALER TEST THE O2 SENSOR FOR PROPER SWITCHING, RIGHT NOW IT SHOWS ALWAYS LEAN, THIS MAY BE THE SENSOR OR THE ENGINE MAY REALLY BE LEAN ON FUEL AIR RATIO, AS FAR AS THE SMOKE GOES THE 2 ARE PROBABLY NOT RELATED, HOW MANY MILES ON CAR? IF THE MILES ARE HIGH THEN REPLACE THE O2 SENSOR ON THE CYLINDER BANK WHERE # 1 CYLINDER IS LOCATED, THE SENSOR IS THE ONE BEFORE THE CATALYTIC CONVERTER.

May 08, 2009 | 2000 Chevrolet Monte Carlo

1 Answer

Spark plug wiring


the firing oder is 1-8-4-3-6-5-7-2 at 4 degrees before top dead center\turn the crankshaft pulley to 4degrees, then the rotor should be pointing at the no.1 cylinder,

Aug 02, 2008 | 1985 Chevrolet Monte Carlo

Not finding what you are looking for?
2000 Chevrolet Monte Carlo Logo

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...