Question about 2000 Mazda 626

1 Answer

2000 Mazda 626...turn key on...no fuel seems to get to engine...fuel tank is full...could fuel filter restrict and cause problem ?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

Check the fuse for the fuel pump. if its bad replace it if it blows again change the fuel pump its on its way out

Posted on Apr 26, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 mazda 626 driving down highway then just dies.. timing belt or fuel pump/filter?


By you saying the engine "Dies" I am going to assume it restarts.
If the timing belt failed the engine would not start again until the belt was replaced.
So it could be a fuel or electrical problem.

Jun 10, 2013 | 2000 Mazda 626

1 Answer

2000 mazada 626 on sometimes will not start. starter engages, spark to plugs, and I can hear the fuel pump running. after it sits for a while it will start and run for a week before it happens again. I...


Check fuel pressure
The fuel pump may be worn out &
binding up every few days & stopping
the fuel to the engine.
Then you have other items that a repair shop
can check, that may be causing your problems.

Sep 16, 2011 | 2000 Mazda 626

1 Answer

2000 mazda 626 2.0 Stalls after filling up fuel tank then goes away until fill up again. No check engine lite


Check evaporative system purge valve.
Sorry , don't know the location on that car.

Jun 08, 2010 | 2000 Mazda 626

1 Answer

Trying to troubleshoot gas not getting to the engine


Most mazdas have electric fuel pumps in the tank,Check fuses and relays first ( relays in engine bay ).If all electrics ok, have a look under the rear seat to see if there is a large 150mm cover plate, remove it and you should see the top of the fuel tank. Unplug the wires , two of them will be for the pump, check to see if there is power when the key is turned on. If not , remove the pump from the tank and get it tested and replace if necessary.
Make sure there is no contamination in the tank ( plastic, rag etc ) that caused the pump to fail in the first place.

Apr 17, 2010 | 2000 Mazda 626

1 Answer

2000 mazda 626 fuel filter location.engine sputters at 55-60 mph


it should be on the driver side. very hard to get to. look under the air box were the air filter goes.
j.aguilar

Feb 03, 2010 | 2000 Mazda 626

1 Answer

Fuel issue


fuel filter is between the tank and engine, usually under the hood. replace the fuel pump.

Sep 27, 2009 | 2000 Mazda 626

1 Answer

When accelerating the engine seems to stutter.


Try unplugging your Mass Air Flow Sensor (MAFS) - you'll find it on top of the metal body immediately after the air filter. I went through an 18 month ordeal - replaced fuel filter, fuel pump, dropped fuel tank and cleaned it, ran 55 gallons of fuel injector cleaner through the system - nothing! After reading some blogs on this car/engine, gave the MAFS unplug trick a try. The car instantly corrected itself (when you unplug this sensor, the engine control module reverts to factory default, allows sufficient fuel into the engine for unitterupted performance.) However, if this corrects your problem, it's only a temporary fix. Run it about 3 days - it you notice soot in the tailpipe, the factory default is running too rich. Replace the MAFS.

May 19, 2009 | 1997 Mazda 626

2 Answers

Need to know where the fuel filter is located please to replace


do you mean it wont start ? if it runs but feels like its low on fuer try running it ( not driving it ) with the fuel cap removed and see if this cures it the air vent maybe blocked and causing a vacume in the tank , hence the fuel will struggle to get to the engine , , worth a try

Dec 16, 2008 | 1999 Mazda 626

Not finding what you are looking for?
2000 Mazda 626 Logo

Related Topics:

560 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...