Question about 2000 Toyota Tundra

1 Answer

2000 Toyota Tundra 4.7 V8 when warm it idles down to zero.

2000 Toyota Tundra 4.7 V8 (2UZ-FE engine) has 76,000 miles.
I need to set the idle up a little. Engine dies at all stops.
Looked it over, cannot find any adjustment.
Dealer wants $350 for this.
I cleaned all air flow to the intake manifold butterfly.
Yes, Mass Air Flow sensor looks clean & good (3-wires OK).

Please hurry.....need fix by Wednesday April 28th.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Toyota Master
  • 24,715 Answers

Your question has risen again by the look of it. It is now July 18th 2017. April has long gone.

Posted on Jul 18, 2017


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 218 Answers

SOURCE: Which vacuum line in Toyota's 2UZ-FE V8 for SeaFoam?

why add seafoam?

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Lexus lx470 on the left bank cam which dot do i line up 1 dot or th 2 dots

here's a u-tube link for a very detailed demonstration of the whole procedure, the actual vehicle in the video is a lexus lx 470
How To Change The Timing Belt In Toyota V8 2UZ FE 3UZ FE Tundra Sequoia...

Jul 24, 2014 | 1999 Lexus LX470

1 Answer

2001 toyota tundra wont turn over and smelling gas

flooding (check fuses , always)
has 50 causes.
ever do the service on this engine?
which engine?
3.4 L 5VZ-FE V6
190 horsepower (2000-2004)
4.7 L 2UZ-FE V8
245 horsepower (2000-2004)

if the engine is not bad, (bad compression, do to skipping service)
its lost park or is excessive fuel injection
ir sure park is good (simple test)
we use the opr, guide way called unflood mode.
you crank with throttle at WOT, wide open throttle , this act cuts all fuel
and she starts.
if not , its got bad spark or bad engine.

there are just 3 tests
1: compression good.
2: spark good to all cyl.
3: fueling checks.
sometimes its lack of air , (fails #3) and that is because the cold start air supply is DEAD> causing rich starts.
so start car with 10% throttle, creating a virtual start up air supply.

its one of those 3, we use a set of $60 guages to find it.

Dec 17, 2013 | Toyota Highlander Cars & Trucks

1 Answer

Firing order for Toyota Tundra 2006 v-8

Toyota Tundra 4.7 liter DOHC V-8 (2UZ-FE)

Hope helps; leave us a testimonial comment about thius free answer. Have a nice day and thank you for using Fixya.

Oct 14, 2011 | 2006 Toyota Tundra

1 Answer

Firing order for Toyota Tundra 2006

Check this diagrams for each engine sizes...

4.7 liter DOHC V-8 (2UZ-FE)


2.7 liter DOHC L4 (3RZ-FE)


Hope this helps (remember to rating this free answer).

Oct 14, 2011 | 2006 Toyota Tundra

1 Answer

Just clicks, how to replace starter( v8) do take manifold off at valve cover or the mid screws


On all engines except the 2UZ-FE, the starter is external, mounted in a conventional manner, alongside the engine block. One the 2UZ-FE, however, the starter is mounted in the 'V' of the engine, between the cylinder head banks. The entire intake manifold assembly must be removed to access the starter motor and solenoid. (Toyota calls the solenoid a "magnetic switch.")
Except 2UZ-FE Engine

0900c15280261920.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Unfasten the starter mounting bolts . . .

0900c15280261921.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. . . . then pull the starter toward the front of the vehicle to remove it (other components removed for clarity)

  1. Disconnect the negative battery cable.
  2. Remove the nut and disconnect the battery cable from the magnetic switch on the starter motor.
  3. Detach the remaining electrical connections at the starter.
  4. Remove the nuts and/or bolts securing the starter to the bell housing, and then pull the starter toward the front of the vehicle to remove.

To install:
  1. Insert the starter into the bell housing being sure that the starter drive teeth are engaged with the flywheel teeth, NOT jammed against the flywheel.
  2. Tighten the attaching hardware to 29 ft. lbs. (39 Nm) and replace all electrical connections.

0900c15280261922.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Exploded view of a common starter mounting found on Toyota trucks

  1. Connect the positive battery cable (starter wire) to the starter.
  2. Connect the negative battery cable.

Jan 28, 2011 | 2000 Toyota Tundra

1 Answer


The left (drivers) side cylinder head is numbered from front (radiator)

The right (passenger) side cylinder head is numbered from front

per 2001 Toyota repair manual page EM-103 and 105. The numbers are not on the engine, from what I can see, but the manual is very specific on this info.
2001 Toyota Tundra Access Cab SR5 2WD
4.7 liter DOHC V-8 (2UZ-FE)92780649.gif 2001 Toyota Tundra Access Cab SR5 2WD
3.4 liter DOHC V-6 (5VZ-FE) 92873946.gif

Jan 18, 2011 | 2001 Toyota Tundra

2 Answers

02 Toyota tundra won't idle. I put a new battery on and cleaned air filter

sounds like a bad idle control long as you're driving it and giving it gas it runs somewhat ok right? it won't idle by itself,or it idles up and down by itself and then dies?thats a sign of a bad idle control sensor,some times they straighten up after the engine warms up and run fine.but eventually go completely bad and won't idle at all. hope this helps and thank you for choosing

Jan 09, 2011 | 2002 Toyota Tundra

1 Answer

What is the spec for fuel pressure on a 2000 tundra 4.7 v8 so i can check for pressure regulator or fuel pump problems.

according to haynes manual at idle should be 38-44psi residual fuel system pressure nafter shut down for 5 min 21 psi mininum

Oct 23, 2009 | 2000 Toyota Tundra

2 Answers

2000 Toyota Tundra 4.7L V8 Rough Idle

Clean/Inspect Intake, MAF sensor, IAC valve for proper operation. Also check for vacuum leaks within the air intake hose and intake components. Hopefully this helps

Jul 20, 2009 | 2000 Toyota Tundra

Not finding what you are looking for?
2000 Toyota Tundra Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8830 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides