Question about 1993 Honda Accord

1 Answer

The Clutch is stuck to the floor? - 1993 Honda Accord

Posted by on

  • ek5soccer Apr 25, 2010

    Where is this Slave Cylinder?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Check the slave cylinders fluid level in the reservoir It will have a cap on it marked clutch fluid. If empty fill it and pump the clutch 25 times and then try it out. If the leak persist the slave cylinder will need to be replaced

Posted on Apr 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 pontiac grand am clutch pedal stuck to the floor


Is it just sunk to the floor or actually stuck? Possible linkage broken, or broken return spring on clutch plates. If it is actually stuck, then I would guess jammed linkage or damaged input shaft splines.

Apr 11, 2013 | 2003 Pontiac Grand Am

1 Answer

1996 nissan maxima clutch squeals pedal stuck to floor


Sound like you're going to need a whole new clutch assembly, but if the fluid level was dry you may have sucked air into the system which means that the clutch will have to be bled at the slave cylinder, just like you would brakes. The squealing sound is coming from the throw out bearing, usually when the do that it means that the bearing is frozen and cannot spin. Either way it looks like you'll be dropping the transmission to work on the clutch.

Jan 30, 2013 | 1996 Nissan Maxima

1 Answer

I own a 1995 Audi 90cs. My clutch peddle started being dead tell half way down then got preshure. Now there is no preshure and the peddle sticks to the floor. There was no slipping in the clutch so I


You need to replace the clutch slave.....Ii recently did mine, after the installation it was stuck too.......the way I fix it was I had a friend pumping the clutch by hand while I bleed it under the car, it took about 15-20 minutes before it got hard again.
Good luck!

Aug 01, 2012 | 1995 Audi 90

1 Answer

CLUTCH WENT TO FLOOR WONT ENGAGE


My guess would be you have a leaking slave cylinder & you have run out of fluid. Check your clutch master cylinder & top up if empty. If so replace the slave cylinder

Jun 21, 2012 | Volkswagen Jetta Cars & Trucks

1 Answer

Clutch peadle is stuck to the floor


CLUTCH TO THE FLOOR, YOU COULD HAVE BROKEN RELEASE BEARING OR FORK,COULD HAVE BROKEN OR DISCONNECTED CLUTCH CABLE.

Jul 07, 2011 | 2004 Chevrolet Cavalier

2 Answers

My clutch is on the floor , is there any temporary fix


When the clutch pedal is stuck to the floor - most likely the master clutch cylinder seal is leaking clutch fluid. Temp fix is to refill the clutch fluid canister and pull the pedal back by hand. Do this several times till the presure is back.

Long term fix is to replace the seal in the master and slave clutch cylinder.

Jul 03, 2011 | Mitsubishi 3000GT Cars & Trucks

3 Answers

I have a 1996 isuzu rodeo 4wd v6 and the clutch pedal is stuck on the floor and the car is stuck in second gear. I'm not sure what to do the clutch won't spring back and right before the cluch got stuck on...


check the rod or cable have someone pull the pedal up when you are under the driver side of the car and you should be able to see what is loose on the transmission some have a spring to return the clutch to its normal location the gear is stuck because the clutch is not working hope this helps you

May 09, 2010 | 1996 Isuzu Rodeo

1 Answer

Pop & clutch stuck to floorboard


probly the clutch fork or through bearing

Apr 05, 2009 | 1995 Isuzu Rodeo

1 Answer

Clutch Pedal to Floor


slave cylinder needs replaced

Nov 12, 2008 | 1991 Jeep Wrangler

Not finding what you are looking for?
1993 Honda Accord Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...