Question about 2006 Kia Sorento

1 Answer

I have a 2005 Sorento and have had no luck with the dealership in identifying a studdering in the front end when I make tight turns. It feels like the front tires are slipping. We have replaced the clutch plates and front and rear bushings, the vibration is still there! I can't afford to keep "parting it out"!

Posted by on

  • gilmore_bill May 11, 2010

    which is it....studdering or slipping?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 244 Answers

Check power steering fluid, is it rear wheel dive, 4X4 ?

Posted on Apr 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 Kia sorento front end vibration when turning


Check front wheel bearings for adjustment. Check cv joints are not worn. Check suspension rubbers. Check tie rod ends for wear. Check the bushes of the tie rods that hold the wheels in alignment

Feb 25, 2013 | 2011 Kia Sorento

1 Answer

I had new brakes installed on my 2005 Kia Sorento and now the brake pedal seems softer. I have to push it almost to the floor to brake.


Sounds like the rear brakes are not adjusted - may not be tight enough.
You could also have air in the lines.

Aug 15, 2012 | 2005 Kia Sorento

1 Answer

Any suggestions on fixing front end noise in my 2005 Chrysler 300:


When you replaced the struts they should have changed strut mounts also, that is where noise comes from, check your reciept.
Also, I have seen mounts, tie rod ends and ball joints loosen over a period of time, so have all your bolts and nuts rechecked for looseness.

Mar 03, 2017 | 2005 Chrysler 300

1 Answer

I have a 2005 KIA Sorento with a Battery problem. The Battery dies & has a dead short after a few months. The auto was purchased NEW with a GPS tracking system installed a dealer from Southwest...


If an ammeter is connected between the negative cable and the negative terminal of the battery with the negative cable end disconnected to do so, then the amp draw should be less than .2 Amps.

If the ammeter is the inductive type that has a probe that goes around the negative battery cable, while the negative battery cable is connected, and the positive is connected, the draw should also be less than .2 Amps.

If the draw is .8 Amps, for example, then that's too high and can cause a dead battery in a few months.

Good luck on this repair.

Nov 27, 2010 | 2005 Kia Sorento

3 Answers

Would bad cv joints make the front end shake at 60 mph


Not likely, this kind of problem is almost always caused by wheels that are out of balance. Have the front wheels rebalanced at any tire shop.

Jan 31, 2010 | 2005 Chevrolet Equinox

1 Answer

Hi, i have a kia sorento 2.5 diesel 54 reg, when


I suggest you to check the vacuum hose condition from front diff it may be disconnected,leak or have damage

Jan 11, 2010 | 2005 Kia Sorento

1 Answer

Knocking from front end


if there was any abnomal wear on old tires then i wood suspect ball jionts, other than that it could be a motor mount or posibly a tranny mount, good luck

Dec 21, 2009 | 2005 Dodge Grand Caravan

1 Answer

Car shudders at low speed when turning


This sounds like there is something worn in the steering. If it is a rack & Pinion steering the rack could be worn out. It could also be the CV joints to the front hubs. Regardless it does not sound safe. Take it to an independent mechanic, NOT THE DEALER, and have it inspected. There typically is not charge to inspect/identify the problem.

Jun 26, 2009 | 1998 Jeep Cherokee

1 Answer

Steering concern when making slow turns or backing out of garage


Make sure that the coupling shaft from the column to the rack is tight at both ends. There is a pinch bolt on the ends. If they are tight try holding the shaft while turning. You will probably feel the clunking noise. If so replace the shaft.

Nov 27, 2008 | 2004 Chevrolet Malibu

Not finding what you are looking for?
2006 Kia Sorento Logo

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...