Question about 1998 Honda Civic

1 Answer

My car wont start and i cheked all most every thing it cranks over but dos not start i put a new mane relay ther is fuel flowing int has to be the computer or the Wires i need halp wat do you suggest

Posted by on

  • Dan
    Dan May 11, 2010

    Was any recent work done?

    Do you know if all fuses are good?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Check and see if there is fire to the plugs. All the fuel in the world won't ignite without a flame.

Posted on Apr 25, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I washed the engine on my 2003 toyota tacoma 4 cylinder while it was running, it turned off and now wont start


Water went in relays,computer mane it thats a desaster try drying as mush part as you can saw that hapen too many time everybody ask me clean my engine its dirty i always tell them so what its dirty and after i tell the story about the with a town car

Apr 12, 2015 | 2003 Toyota Tacoma

1 Answer

Car cranks but wont stay running


Only a few things will cause a stalling first is crank position sensor and second is the mass air flow sensor followed by the fuel pump or relay. you need to first find out if your fuel pump output is 45psi i it has good fuel pressure then i recommend you replace the crank position sensor.

Feb 25, 2015 | 1995 Buick LeSabre

3 Answers

Why is it that my 2003 impala will crank and turnover but wont start


I sounds like you have a fuel flow problem. Replace the in-line fuel filer located in the fuel line in front of the rear tire. Check out this web site for "how to" replace the in-line fuel filter.
http://www.ehow.com/how_6724057_install-filter-2003-chevy-impala.html

Aug 15, 2014 | 2003 Chevrolet Impala

3 Answers

On my 1999 plymouth breeze 2.0 sohc. it cranks but wont start. Relays , fuses are good. But i dont hear the fuel pump


First key on you should hear pump run a couple seconds if you think it's the pump have someone crank it over and another pound on the fuel tank this sometimes makes the pump motor start to run, if it does that may be enough for you to drive to a shop for a new fuel pump.

Apr 22, 2014 | 1999 Plymouth Breeze

1 Answer

Starter avalanche


you need to give more detiles, dos it crank up or not, is it turning or not, also check if the wires are all back on after your both repairs!

Oct 25, 2013 | Cars & Trucks

1 Answer

2002 chevy malibu cranks but wont start


you should check the battery, if it is all right, you should try to check the starter and ignition.
_____________
Launch X431

Jun 17, 2013 | Cars & Trucks

1 Answer

It does not start anymore and has no spark


first remove starter and have it tested at parts store. Might make it turn over better. Second thing to check is the battery and starter connections. Battery check is usually free too. if it restarts how do you know there is no spark? pull a wire off and hook to loose plug. lay plug on air cleaner and crank in dark place. another thing to check would be fuel filter. if air flows freely it is good. also check for water in filter this could block gas flow. Can I assume tuneup and air filter are good? next is harder to do. Check fuel pump relay by switch it with another of the same type. will watch for more later.

Jan 27, 2013 | 2002 Pontiac Sunfire

1 Answer

My 95 audi a6 2.8 none turbo wont start but cranks


had the same problem so i took my battery to the auto shop 4 a full recharge 240 min. then put back in car and it started.

Oct 13, 2012 | 1995 Audi A6

1 Answer

I HAVE AN 87 ACURA INTEGRA.I WONT GO OVER 30 MPH WITH OUT JERKING OR SOUNDING LIKE ITS OUT OF GAS. I HAVE A FAIRLY NEW FUELPUMP ON IT NEW FUEL FILTER AND CHEKED THE FUEL PRESSURE 60PSI . IT CRANKS AND...


If one of the sensor goes bad, you will see PGM-FI check engine light would come on.
The normal fuel pressure for this car is between 36 to 41 psi.
Check for pinched or clogged fuel return hose or piping.
Check the fuel pressure changes by removing the vacuum tube on the top of the fuel pressure regulator and next check the pressure this time with pinching on the return hose that is attached to the pressure regulator.
You will need to put a shop towel over the return hose and use pliers.
If no change in the pressure reading, replace the fuel pressure regulator.

Jun 10, 2010 | 1987 Acura Integra

1 Answer

1992 mits 2.4 L pickup [ new ecm,fuelpump,fuel pump]


I had the same problum with my 91and i changed the ecm relay. I got the part from parts america and though the shop it was about 80$

Jul 25, 2009 | Mitsubishi Mighty Max Cars & Trucks

Not finding what you are looking for?
1998 Honda Civic Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...