Question about 2004 Jeep Grand Cherokee

Open Question

Power windows and locks on driver side door

My power quit working on my driver side door, i opened it up and found the black wire was split, replaced it with and extra 6' piece of wire worked for about two months then quit. i checked it again and its still all attached. could there be a fuse out, and what wire is the power and which is the ground.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 110 Answers

SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work

i had same problem on my jeep i disconnected the battery then reconnected everything worked fine after that

Posted on Nov 25, 2008

Mikey108
  • 475 Answers

SOURCE: Power windows dont work and the same problem with the power locks

the harness that is between the drivers door and the "a" pillar probably has some wires broken.

Posted on Dec 23, 2008

  • 2 Answers

SOURCE: 2004 Jeep Lerado - Drivers Side Power Windows & RemoteKey Issue

A wire in the rubber boot in the door jam is broken,i found it in my jeep GC 04 yours shouls be the same..

Posted on Jan 05, 2009

  • 6982 Answers

SOURCE: power door locks and windows

The answer to your question is maybe. Get a couple of switches from a junkyard (my guy gets $5.00 each) and try them. Here's why: I have no less than five different wiring diagrams, and none of them make any sense at all (been doing this stuff a really long time) I keep a good switch handy to check my jeeps when one gets wierd on me...even so, my 93 passenger window works with the key off, none of the others do. Stopped trying to figure it out a long time ago, but would really like to meet the guy who designed this stuff!

Posted on Feb 22, 2009

  • 412 Answers

SOURCE: 1999 Jeep Cherokee (not Grand) driver door power control

there is a rubber boot between door and body,peel it back from each end and will expose wiring..try pulling on each wire and you will more than likely find 1 or more broken wires..happens because driver's door is used the most..have seen this on these vehicles..wiring can be repaired

Posted on May 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont windows and lock work? could it be the front ecu?


Check inside of door where wiring comes thru for broken wires ,ECU doesn't control windows or door locks. You didn't state what model vehicle you own. But opening and closing door on drivers side causes broken wires on numerous vehicles over the years, most makes and models. Split boot and check all wires inside for breakage.

May 29, 2014 | Mitsubishi Galant Cars & Trucks

Tip

The power door lock and windows do not work on passenger side of 2004 Grand...


If the power door lock and windows are not working on the passenger side of your jeep then it’s the fault in the wiring's.please check out the following option mentioned below to resolve this problem:--
There is a black ground wire. Its located in the wiring harness.
The black ground wire in the wiring harness that goes between the drivers door and the kick panel of the jeep is probably got split or got cut in between. The wire is located inside the black rubber accordion box which looks like a boot/cover. You need to splice a longer piece of wire and connect the two broken ends of wire together to repair this problem.

on Feb 28, 2010 | Jeep Grand Cherokee Cars & Trucks

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere


First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

2 Answers

Power windows and locks stopped working but only on the driver side


open driver's door, and check wiring between the door and hinge pillar due to open and closing the door, the wiring will break, use a razor knife and split the rubber cover and check for a broken wire, solder as needed. if no wire is broken, suspect master switch on the driver's door.

Jul 27, 2010 | 2006 Chevrolet Trailblazer

2 Answers

Door locks and power window


Just did this procedure I got from coloradofans.com forums:

"any type of power/voltage change seems to trigger this issue

The most common symptom is power locks fail and only the driver window quits, however that is on the extended cab.

Steps to fix and it works every time.

take door panel off driver's door
Disconnect the wiring attached to window and power lock control unit
disconnect battery cables
connect the negative to the positive cable(((NO BATTERY CONNECTED)))
This will act to short residual voltage in the system

5 minutes later
place the key in the ignition and turn to the run position
connect the wiring to the window/lock controller
connect the negative cable to the battery
then the positive
open drivers side door
turn key to the off position((do not remove yet)) you should get a series of dings through speakers telling you the key is still in the ignition
once it begins dinging pull the key out and you should hear the door lock solenoids trigger and the windows should work." - Coloradofans.com forums

Mar 01, 2010 | 2006 Chevrolet Colorado

1 Answer

The power door lock and windows do not work on passenger side


The black ground wire in the wiring harness that goes between the drivers door and the kick panel is probably split. It is inside the black rubber accordian looking boot/cover. need to splice a longer piece or use a crimp splice to repair.

Jan 21, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Camry 1996 automatic power lock doen't work, but windows work.


if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks

Jul 20, 2009 | 1996 Toyota Camry

2 Answers

2000 mercury mountaineer power windows won't work


check for a broken wire in the wiring between the body and door

Nov 30, 2008 | 2000 Mercury Mountaineer

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

17 Answers

Power windows, door locks and mirrors inop.


Sounds familiar - I pulled the rubber boot back and found the black wire was broken. I stripped the wires and put on a couple bullet connectors (terminators) and all is good. Just wish I would have seen this post before I took the door panel off... Oh well...

May 21, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...