Question about 1999 Chrysler Cirrus

Open Question

How do I replace a window washer pump for a 1999 chrysler cirrus

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fischmilch
  • 96 Answers

SOURCE: 1999 Chrysler Cirrus Lxi 2.5l high rpm

The throttle position sensor may be misaligned. This tells the computer how much throttle is being applied, and when they go bad, or come out of alignment, the idle tends to get up there. If that's not the issue, remove your air cleaner, the housing and everything until you get to the MAP sensor. Give it a good spray with carb cleaner, let it dry and replace the air cleaner with a new one. If the MAP sensor detects minimal air flow, the computer jacks up the idle to compensate.

Posted on Nov 07, 2008

Ad
fischmilch
  • 96 Answers

SOURCE: 1999 chrysler cirrus

Check the coil packs, or the Ignition module. Disconnect the harness to the ignition module. And test the leads to see if there is current. I don't know what the specs should be, but it will be minimal. Never overlook fuses either.

Posted on Nov 07, 2008

Molson02536
  • 3854 Answers

SOURCE: 1999 chrysler cirrus transmission will not shift

It sounds like it may be you speed sensor at the transmission which is also called Vehicle Velocity Sensor (VVS), The sensor or the wire harness may have gone bad and needs to be replaced, but it's a good thing to have your car scanned at Auto Zone since they scan free of charge. I just want to make sure it is the VVS and not the transmission Control Module (TCM), Check the fuse under the dash and under the hood and look for any blown fuse like the TCM fuse. Good luck and hope this helps, keep me posted

Posted on Jun 24, 2009

  • 4 Answers

SOURCE: how to change a 1995 chrysler cirrus water pump

ok i did 3 days ago i ahave 1995 chrysler cirrus u have to remove timing belt if u wane step by step u can call me at 916 200 5492 i live in sacramento so if u wane i can do it for you

Posted on Mar 04, 2010

  • 149 Answers

SOURCE: 1999 chrysler cirrus stalling problem with fault

p0455
Evaporative emission
(evap) control system leak detected (no purge flow or large leak)

Posted on Aug 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the book say in hours to replace the timing / water pump on a 1997 chysler cirrus 2.5 v6 ? Or in your opinion what's a fair price to have this done by private person coming to the house .


Replacing Chrysler 2.2 and 2.5 liter engine timing belts

www.allpar.com/fix/timing-belt-22.html
Replacing the timing belts on Chrysler and Dodge 2.2 and 2.5 liter ... Then loosen the bolts on the crankshaft pulley and the water pump pulley so they will be ...

HOW TO PUT WATER PUMP ON - 1997 Chrysler Cirrus

repairpal.com > Questions > Chrysler > Cirrus > 1997 Chrysler Cirrus
Jul 4, 2010 - WATER PUMP WANT HOLD WATER LONG AND NOW IS MAKING A ...If you change the water pump,you need to also change the timing belt ...

Timing belt - 1995 Chrysler Cirrus - RepairPal


Nov 24, 2015 | Cars & Trucks

1 Answer

Why does it shut off while i'm driving?


Fuel pump problem... common problem with Chryslers. Try replacing the fuel pump relay first as it's easiest to see if this fixes your problem.

Jul 26, 2015 | 1999 Chrysler Cirrus LXi

1 Answer

1999 CRYSLER CIRRUS,REPLACED THE CRANKSHAFT SENSOR BUT STILL NO SPARK


try the auto shutoff relay.. it controls the fuel pump and the igniton circuits..

Dec 15, 2013 | 1999 Chrysler Cirrus

1 Answer

1999 chrysler cirrus will not start


make sure you have a good solid ground for fuel pump @ tank ! I can\'t express this enough. Is power getting to pump ! can you hear it run when you have an assistant turn key to on position ? it will hum for 2-3 seconds. computers rarely go bad ! just heard about a new fuel pump was wired wrong @ the manufactors who built it. that would suck. good luck

Feb 05, 2013 | 1999 Chrysler Cirrus

1 Answer

I need torque specs to change a water pump for a 1999 chrysler cirrus 2.4 liter engine. water pump torque specs.


dont know the specs but you should be ok if you tighten the bolts snuggly and then 1/2 turn this will usually suffice just be careful not to over tighten

Nov 01, 2009 | 1999 Chrysler Cirrus

1 Answer

Where is oil sending unit location on 1999 chrysler cirrus 2.4 ?


most likley place is on the engine block look for it there

Oct 24, 2009 | 1999 Chrysler Cirrus

1 Answer

How do you install a fuel pump on a 99 chrysler cirrus


fuel pump is under the rear seat on right side in fuel tank you have to remove seat

Jul 30, 2009 | 1999 Chrysler Cirrus

1 Answer

How to replace fuel pump on 95 chrysler cirrus.Need detailed instructions on how to remove and replace fuel pump module on 1995 Chrysler cirrus.


to detailed to explain here. buy a hanynes repair manual at local auto store, 17$ it'll explain step by step.

Jul 01, 2009 | 1995 Chrysler Cirrus

1 Answer

1999 Chrysler Cirrus Lxi 2.5l high rpm


The throttle position sensor may be misaligned. This tells the computer how much throttle is being applied, and when they go bad, or come out of alignment, the idle tends to get up there. If that's not the issue, remove your air cleaner, the housing and everything until you get to the MAP sensor. Give it a good spray with carb cleaner, let it dry and replace the air cleaner with a new one. If the MAP sensor detects minimal air flow, the computer jacks up the idle to compensate.

Nov 07, 2008 | 1999 Chrysler Cirrus

1 Answer

Fuel will not pump to engine


FUEL FILTER IS PLUGGED UP

Sep 07, 2008 | 1999 Chrysler Cirrus

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...