Question about 1995 Dodge Intrepid

1 Answer

At idle rpm goes from 800 normal to 1600 and engine shuts down

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 972 Answers

Clean throttle body first

Posted on Apr 27, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

RPM's go high when driving but then go back to normal


What you are describing sounds normal. RPM's stand for revolutions per minute. Each minute your engine is running, the pistons are going up and down. When you are not going anywhere, your engine is idling and so the RPM's should NOT be very high. However, when you race up a hill, your RPM's SHOULD be high because your engine has to work hard to climb the hill or to go fast.
Idle speed= 650 Revolutions Per Minute. That means your engine cylinders each work 650 times in One minute.
At freeway speeds, your engine will revolve somewhere between 1600 and 2100 times per minute. I hope that helps.

Apr 20, 2015 | Cars & Trucks

1 Answer

Toyota corolla hatch 2002 idle at 2000 rpm when


All the above is normal , except 2000rpm is a little high at idle . can be adjusted down to 1500rpm. the computer adjusts the engine speed . in drive the transmission loads up the engine idle drops to 1000rpm . in park engine unloaded rpm increase all normal.

Sep 17, 2014 | Cars & Trucks

1 Answer

F 150 shuts off when y I u turn a/c on 5.4 3v


the engine stalls. (i bet only on a hot engine, , am i right?)
this can be 2 things. but with this huge of engine 1.
the engine idle controls are not idling up.
or extreme, the engine is too weak and the compressor has issues.
does the car driver perfect A/c off? full power and normal hot
engines. and idle speed is at spec hot. near 800 RPM?
(spec, rpm is stated clearly on the hood sticker) open hood look up and under. see that EPA sticker, ?

if RPM is normal. hot.
the engine has huge power.
you turn on A/c and the rpm must not drop
did you try to push the throttle down to prevent the stall.
did that work> yes./no,
if yes,did the A/c belt squeal>?
if that cant work and belt does not scream, the engine has very low power.
the ECU increases idle speed when the A/C is on. this prevents stalls.
this can fail, if the ISC is bad. or diry.

Jun 28, 2014 | Cars & Trucks

1 Answer

Idel problem on 5.7 1995 silverado


You engine is TBI, It uses a MAP sensor check the vacuum line for crack and make sure yo have a good seal, The distributor also check and make sure the pick up does not have corrosion which causes the relutor to stick. As for the EGR it would cause a misfire, and yes the do fail. I am sticking with the IAC as a problem its a stepper motor and has a high failure rate, chack also the ECT (engine coolant temp sensor) for corrosion that gives false reading.

Mar 05, 2012 | Chevrolet Silverado Cars & Trucks

1 Answer

High --1600 rpm ?? rpm idle


The normal idle speed is below 1,000 rpm...between 800 to 900 rpm. I suspect that the idle-air control motor has seized and can no longer automatically adjust the engine's idle speed. This part is also responsible for slightly increasing idle speed when the airconditioning is switched on to compensate for the added engine load. Some cars even have a "step-up" solenoid to increase idle.

When replacing the idle-air control motor, remember to clean the port that IAC motor goes into; there will be some carbon build-up that may prevent the part's cone-shaped valve from seating properly. A can of intake valve spray helped along with some Q-tips works well.



Hope this helped.

Have a great day !!!

Apr 07, 2011 | 1992 Buick LeSabre

2 Answers

Can you tell me what the idle is set at on a 1991 honda accord


It should be 800 r/pm When the engine is cold it can be a bit more, but thats normal, if it goes down after som 15 min. of work.

Jan 02, 2011 | 1991 Honda Accord

1 Answer

Need to increase my idle to just over a grand. after it warms up the idle drops to around 800 rpm's just low enough to shut the heat off.


Hi,

Please give us the detail of model of you car.

800 rpm is a normal idling for your engine.

Tell us more.

Dec 06, 2010 | Nissan Altima Cars & Trucks

2 Answers

Cold engine, idle rpm 1200 is this normal? 2002 Toyota Carollia


you need to replace the throttle position sensor on the intake.

Dec 16, 2009 | 2001 Toyota Corolla

1 Answer

Ideling 1600 rpm onlywhen engine warm


please change the idling switch control valve assembly plus the sensor!

Jun 18, 2009 | Mercedes-Benz SL-Class Cars & Trucks

1 Answer

94 civic erratic idle when warm


either low coolant or your IAC motor is acting up

Jan 15, 2009 | 1994 Honda Civic

Not finding what you are looking for?
1995 Dodge Intrepid Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...