Question about Land Rover Discovery

Open Question

Looking for a wiring diagram for a lovato 198 Di lpg switch.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Ignition fuses keeps blowing


Hi there I are am a tech mechanic and the fuses are their so you don't have a fire you have a broken circuit in the ignition switch circuit have you check the ground in the colo the switch is ground their next to it that ist where I would start and what fuses are you talking about little or power di. Box you need to do a voltage drop test not ohms test and have you looked up wiring diagram of it exp. You could have ground broke down by fuel pump but you never find it bc you didn't get diagram of the ignition

Oct 21, 2015 | Cars & Trucks

1 Answer

Does an xh ute have the same fuel gauge for gas and petrol. When I change to gas my fuel gauge drops to empty????


Don't know the vehicle at all, but perhaps the gas (I assume you mean something like lpg) gague is sharing the same power set up, ie when switch to gas, the power or sensor wires are then redirected elsewhere, so the fuel gague drops off, till returning to petrol.

See this scenario on a couple of lpg cars here in uk. All lpg cars I've seen do not share a gague though.

May 29, 2015 | Cars & Trucks

1 Answer

Lpg wiring


the fuel gauge works on a float in the petrol tank and wont work on gas . the system will have to be changed to work on pressure .

Aug 16, 2014 | Cars & Trucks

1 Answer

Lpg converted engine wont run using lpg without gasoline in tank


It is normal. All LPG converted engines start with gasoline. Then when they reach 2000 rpm move on LPG system.
If you want to start directly with LPG must call a professional to modify your installation.

Jan 30, 2014 | Cars & Trucks

1 Answer

Picasso 2.0hdi wiring diagram


Do not mess around with this as it is a complete computer unit behind the facia and expensive and the official wiring diagram just shows a block with connections and no colours or numbers but then it is a haynes book so say no more ,it just says typical wiring diagram .Now what you can do is find a three or four click switch from a lod 60s model car then wire it directly into the motor under the passenger side dash where their is the resistor pack.Or pay the money for a new unit ,i also do this for the AC on and off as well ,YES I AM cowboy i admit i can and do bodge these things but wait till you find out the price ,the blower motor is 198+tax alone

Mar 03, 2013 | 2004 Citroen Xsara Picasso

1 Answer

Lpg system has no gas getting to inlet manifold


you might want to check out the lpg regulator , it may have a blockage or some other problem with it. If it's a dual fuel system you mau want to also check the electonic switch that switched it from petrol to lpg. Another thing to check could be the lpg lines and joiners, a leak in these may cause the system to shut down. On top of all of that you may need to check that there is no blockage in the lpg line or the jet where it goes into the manifold. hope this helps.

Nov 26, 2012 | 1996 Jeep Grand Cherokee

2 Answers

Started car running on petrol for 5 minutes with lpg switched on, clicking noise from lpg tank, slight smell of gas, when fuel switched to lpg engine cut out. start again on petrol, switch on lpg again,...


could be number of problems but often this is caused by valve on the inlet manifold which is electricaly operated and then it allows the gas in but it is also vacumn sensitive so a perished rubber pipe could cause it not to sense the vacumn .best advice without seeing it is to visit a mechanic that is conversant with LPG conversion

Apr 12, 2010 | 1997 Ford Explorer AWD

1 Answer

Using petrol while switched to lpg


get a fitter to have a look as it sounds like a shut off valve needs some new seals to me

Oct 08, 2008 | 2003 Renault 181

1 Answer

LPG not working?


You will have to recheck that all the wires were reinstaled.The noise is the fuel pump.The lpg system has its own fuses so you will have to check them also.The only thing you touched was the battery so the problem is there somewhere..Earth wire is also important just double check all the things you undid.Let me know how you go

Jul 30, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

546 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...