Question about 2001 Toyota MR2 Spyder

1 Answer

My mr2 is leaking right where the top meets the body of the car by the door, you can see light from the inside where the watter is coming in. is there any way to fix this it just started not to long ago. and all the water goes in the compartment behind the seats

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

I have the same issue with mine. I read what's below on convertibletopguys.com, and I wonder if that's not what has happened. Don't know if there is a fix or if replacement is the only option.

Cable Redesign:
In the last two years of the MR2 manufacture, Toyota made a modification to the hold down cables in order to eliminate a tearing problem experienced by many owners of the earlier MR2 tops. The cables sewn into our tops have the improved Toyota configuration cables pre-installed.

Posted on Jun 08, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The leak I have in my 2006 HHR is clear, on the passenger side, and only happens when it rains. I do not see anything around the windshield, but it goes through the glove compartment and on to the flo


A good trick to finding exactly where it is leaking from is to take flour or baby powder, and very lights dust the entire inside area where the leak could be coming from. Do this right before you know it is going to rain and it will leak. when you go out to check it after the rain, it should be very easy to see where the water came in and washed away the powder. I would do it along the rubber gasket around the door from the back edge of the window where it meets the roof, all the way down past the door hinges, as well as the windshield.

Jul 17, 2014 | 2006 Chevrolet HHR

1 Answer

Mazda Bt50 cab leaks on drivers side


I recently purchased a 2008 BT50 dual cab then 2 days later we had 500mm of rain and of course it leaked :( I had about 80mm of water on the drivers side floor and 30mm on the passenger side floor. I stripped the interior out of the car and started hosing the outside and watching where it was coming in. I took all the windscreen surrounds off and the cowl panel off below the screen there was no water coming in from that area. I had taken the gutter seals off but left the door seals on so the water was running down around the outside of the seals (with the door shut) and out at the bottom. From inside near the drivers side kick panel I could see water coming through seams in the metal work and when I took the door seal rubber off the body on the car I could see water was getting in at the top of the door seal rubber going down the front inside edge of the rubber and getting in through the seam where the rubber push's onto the body of the car (first problem). I took all the door seal rubbers off and run a bead of non corrosive silicon inside the cavity and pushed them back on. It seemed to have fixed the problem I dried the carpet and put it back together..Two weeks later we got another 325mm of rain and it leaked again :( not near as bad this time. Looking at the bottom of the door where the door trim meets the door I could see water coming from behind the trim and then into the car. I took the door trims off and could see water gets in when the window is up (all cars do) and is supposed to run out the drain holes in the bottom of the door but the water was dripping and splashing up to the back side of the door trim against the sheet of plastic that is supposed to seal against the door with the black mastic (it doesn't) and running straight into the car. I cut some plastic and siliconed them onto each opening on the inside of the door frame and then put the factory piece of plastic on as well (properley this time) as a backup.
So far so good.

May 26, 2012 | Mazda BT50 Cars & Trucks

2 Answers

Where is the vin number on an acura tl?


at the base of the windshield in front of the driver (like all other cars)

Sep 02, 2011 | 2005 Acura TL

1 Answer

06 wrangler leaks on drivers side floor when it rains


I had the same problem, but on the passenger side. This may help. Look on the inside under the door for a seam where the two body panels meet. The seam should be tight, but mine had a good size gap and the water was coming in there. I took a tube of caulk and kept squeezing it in until it came out. No more leaks and I used to get a lake on the floor.

Mike

Oct 18, 2010 | 2006 Jeep Wrangler

2 Answers

I have 2 leaks on my renault scenic, one comes in


why is wet came from inside driver floor inside box store there is water was inside car model ireuault scenic 2004

May 12, 2010 | Cars & Trucks

1 Answer

Water leaking onto the sump unsure if heater hose split


?antifreeze or watter ? inside car or out? if it is leaking inside chance are it is a heater core ..if out side passengers side it could be ac condensation could be inside too if drain is plugged and if it is water if it is watter and not antifreeze the drain is behind Eng lower firewall short black hose with flat end you can clean it with a pipe cleaner sort is the car loosing antifreeze

Mar 11, 2010 | 1995 Mazda MPV

3 Answers

The headlights don't go down when I turn the lights off


You probably blew the fuse on the passenger side inside the Frunk (Front Trunk). The headlights are operated by both relays and fuses. My fuse went out and prevented them from going down. They would go up still.

Sep 22, 2008 | 1985 Toyota MR2

2 Answers

Car won't turnover when key is turned to on position oil light lights but battery light does not come on and engine will not turnover


you sure it is not the entire key mount that is turning as well?
had a friends who had just popped out of place.

Sep 15, 2008 | 1992 Toyota MR2

1 Answer

MR2 DOOR LOCK


sounds like some one tried to break into your vehicle and jammed the door locking rod this would be the most likley guess since you said motor is still working the rod will need to be pulled out and straightened again to factory bend this is critical

and your switch is on the door panel the one that says lock unlock

May 26, 2008 | 1995 Toyota MR2

Not finding what you are looking for?
2001 Toyota MR2 Spyder Logo

Related Topics:

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...