Question about 1995 Jaguar XJ6

Open Question

Tail light problem

Need to change the rear tailight on a Jag 1995 XJ6...How do I know if I need to order the assembly w/wo the fog -light. Is the foglight separate from the actual light assembly??? I am ordering online and I am unsure which one to order. Thanks in advance.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

short shadey
  • 421 Answers

SOURCE: tail / brake light lens replacement

remove the inner plastics on that side and uplug and remove the 10-15 ten mm bolts remove the light and reinstall there maybe some weatherseal holding the light also just yank it out please rate -jeff

Posted on Sep 01, 2008

  • 409 Answers

SOURCE: 1995 Jag XJ6 Rear Issues...need to fix ASAP.

My 1994 Vanden Plas makes the same noise. I know I need rear shocks. You do also!! Have the rear shocks replaced. Bilstein part number B46 1858 or Koni part  number 30 1377. Actually the Bilstein is the better shock and less expensive.

Posted on Dec 29, 2008

  • 133 Answers


Hi the idler valve has a set up with jag equpment but there is a way round this,ifyou have had  O2 sensors changed, is the idler working what are the revs when hot. 650 is to low  850 is ok with a hot engine Mike do you know where the idle valve is and the allen key manual adjustment try a quarter turn but mark it so you can turn it back if need be. let me know how it goes   D    

Posted on Jan 11, 2009

  • 840 Answers

SOURCE: Installing a throttle body for a 1997 jag xj6 4.0liter

yes go to auto store get a book on the vehicle will show you exactly where it is and it just a couple of screws

Posted on Jan 24, 2009

  • 100 Answers

SOURCE: how to change rear struts on 1995 xj6 jaguar

Its not the simple on teh 1995 xj6, the rear axle needs to be dropped down. If you email me I will send you the factory info to replace them

Posted on Feb 17, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I remove the rear bumper on a 2003 hyundai sonata

You have to remove four screws near the center of the rear bumper that are visible when you open the trunk. Then remove the inside upholstery cover for each rear tail light and then remove the four brass bolts that hold each rear tail light assembly. Unhook the wiring harness so the tail light assembly can be removed and laid aside. Then remove the two screws on each side which were covered by the bottom of the tail lights. Next, remove some of the upholestry retaining pins close to the rear tailights so you can access the spcae behind them. You need to remove two brass nuts close to the outer aspect of where the tailights are located and two screws that are located several inches farther forward that are holding the more frontal aspect of the rear bumper on each side. Finally, remove two retaining screws at the bottom of the most forward aspect of the bumper (wheel well) and one at the top of the most forward aspect of the bumper and you should now be able to remove it! Hope this helps! John in Lexington

Jul 20, 2012 | Hyundai Sonata Cars & Trucks

1 Answer

Have 1995 toyota corolla and need to replace rear passenger tail light assembly. Have part, just need to be sure how to replace.

open the trunk you should see wing nuts that attach to the back body of the tailight..... turn counter clock wise..... remove the wires on at a time and label right to left label the wires by color code so you don't get them mixed up and remove unit install new one and reverse removable procedure

Jun 17, 2011 | Toyota Corolla Cars & Trucks

1 Answer

How to replace bulb in front bumper turn signal housing 1995 jag xj6

  • Identify the blown bulb. Note that if a headlight bulb has blown, the dip beam is on the outside and the high beam is on the inside. Turn off the ignition switch and light switches.

  • Open the hood and replace any blown headlight bulbs. Press the plastic spring clips and remove the bulb holder from the assembly. Pull the bulb out of the bulb holder and replace it with a new bulb. It only fits one way. Be sure not to touch the bulb's glass. Replace any parking lights at the same time, they are in the headlamp unit too.

  • Remove the front turn signal light unit in the bumper to change the turn signal bulb. Push gently on the inside edge and insert a blade between the bumper and the lens at the outside edge. Compress the spring and remove the lens. Fit a new lamp by inserting it into the plug. The side marker light is changed using a similar process.

  • Open the trunk to replace the rear fog light, stop light, tail light, reversing light and turn signal light. Remove the rear light cover and turn the bulb holder fastener 90 degrees counter clockwise. Remove the expired bulb, fit a new one and replace the parts, turning the bulb holder clockwise.

  • Thanks..

    May 21, 2011 | 1995 Jaguar XJ6

    1 Answer

    Need to know how to replace rear passenger tail light lens

    Wouldn't it be simpler to just get a used tail lamp assembly on ebay? Most likely any SL tailight assembly 96 to 99 will fit and there are lots of them for sale.

    Nov 11, 2010 | 1997 Saturn SL

    1 Answer

    My tail lights will not stay on. They keep going out.As a matter of fact, i don't think they come on at all now.

    You may have blown a fuse or two. Have you checked fuses?

    RH Tail, Number plate = C7 RH box
    LH Tail, Number plate = C7 LH box

    RH Reverse, Rear Fog = B8 RH box
    LH Reverse, Rear Fog = B8 LH box

    burnt diodes on the back of the dash can give this fault also, have somebody check the electrical contacts...

    Feb 28, 2010 | 1994 Jaguar XJ6

    1 Answer

    Getting access to tailgate window washer motor.

    to remove the fog lamp assy u must go under the truck, it is held in from the rear, there will be a couple of studs and nuts you remove, I am a little confused hear, you have fog lights in the rear of the truck? is this a typo?

    Oct 19, 2009 | 1995 Volvo 850

    1 Answer

    How to change tail light bulb on 1999 buick lasabre

    Remove cover from rear of trunk to access nuts. Remove tailight all 4 nuts. Pull tailight out. You will see the bulb sockets behind the tail light assembly. Turn counter clockwise to remove socket. Install same way.

    Jul 26, 2009 | 1999 Buick LeSabre

    1 Answer

    1995 Jag XJ6 Rear Issues...need to fix ASAP.

    My 1994 Vanden Plas makes the same noise. I know I need rear shocks. You do also!! Have the rear shocks replaced. Bilstein part number B46 1858 or Koni part  number 30 1377. Actually the Bilstein is the better shock and less expensive.

    Dec 29, 2008 | 1995 Jaguar XJ6

    1 Answer

    Tailights on 1995 chevey lumina

    you have to go through the trunk and pull away the fabric this will allow you to have access to the tail light assembly.. please rate this thanks

    Sep 05, 2008 | 1995 Chevrolet Lumina

    Not finding what you are looking for?
    1995 Jaguar XJ6 Logo

    Related Topics:

    22 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Jaguar Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers


    Level 3 Expert

    80531 Answers


    Level 2 Expert

    489 Answers

    Are you a Jaguar Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides