Question about 2004 Mercury Montery

1 Answer

I have check tire coming on information and lights is also coming

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

This means you have a low tire you need to air them up to at least 28 PSI if it is the model equipped with air compressor the air compressor may be malfunctioning, try going to any tire shop and ask them to air your tires up, most will do it for free. If the computer has to be reset they may charge you $15.00 to do it.

Posted on Apr 23, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tire monitor keeps coming on


check the air pressure in all tires and in some vehicles even the spare ---if all tires good and still lit up possible sensor failure --in future could you please enter more information like vehicle

Jun 11, 2017 | Cars & Trucks

1 Answer

My ( ! ) light stays on


Hi there:
Is your TPMS Warning Light On? The Tire Pressure Monitor System monitors the inflation pressure of the tires on your vehicle. If the pressure inside any tire drops 25 percent or more below its recommended inflation pressure, the warning light comes on to alert you.


Should you stop driving and check your tires immediately? It would probably be wise to find a safe place to stop or pull over so you can check the tires. You may just have a low tire that has been slowly seeping air over a period of time. Or, you may have a tire that is going flat. The TPMS Warning Light only tells you the pressure is low in one of the tires, not how fast the tire is losing pressure.


Important: Check the pressure in ALL of your tires, not just the one that triggered the TPMS Warning Light. Why? Because you may have other tires that are also low, but not low enough to trigger the warning light.
If you discover that one or more tires are low, add air to bring them back up to the recommended inflation pressure for your vehicle. You can find this information on a decal which may be mounted in a door pillar, the glovebox, or in your owners manual (which you should carry in your glove box).


5_26_2012_5_47_59_pm.jpg


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

May 26, 2012 | Holden Vectra Cars & Trucks

1 Answer

Tpms light on, dic indicated low tp fr, inflated to proper pressure,tpms stays on, dic wont update


TPMS - TIRE PRESSURE MONITOR WARNING LIGHT
NOTE: Tire pressure rises and falls depending on heat caused by vehicle's operation and the outside temperature. If outside temperature is low, the air inside the tire may cool, causing a lower tire inflation pressure. This may cause the low tire pressure warning light to illuminate.

When the tire pressure warning light comes on, immediately check the air pressure of all tires and adjust to the specified pressure. Make sure the warning light goes off. If the warning light stays on or flashes, there is a malfunction in the TPM system. See appropriate manufacturer service information.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 13, 2012 | Cars & Trucks

3 Answers

My low tire light came on so I went and had air and all the tires checked but now I don't know how to turn the light off. I have had the car since 2000 and it has 50,000 miles on it but could never figure...


Hello Mattingly.

Here is some information for you regarding your problem.

The Tire Inflation Monitor (TIM) system alerts the driver when the pressure changes in one of the tires. The system only detects a low pressure condition while the vehicle is being driven. Once a low tire pressure condition is detected, the system informs the driver that a low tire pressure condition exist's, whenever the ignition is ON.
The LOW TIRE message appears on the Instrument panel if the tire pressure in one tire becomes at least 82 kPa (12 psi) lower or higher than the other three tires. The message does not appear if more than one tire is low or high, or if the system is not calibrated properly. The system does not inform the driver which tire is low. To clear this message, set the tire pressures in all four tires to the proper pressures and perform the system reset procedure. Refer to Tire Inflation Monitor Reset Procedure for service procedure.
The Tire Inflation Monitor software requires approximately one half hour of straight line driving to complete the TIM autolearn. There are several speed ranges that the EBCM needs to learn the tire inflation configuration in order to have the full capability of detecting a low tire condition. The speed detection ranges are the following:

  • 24-64 km/h (15-40 mph)
  • 64-113 km/h (40-70 mph)
  • 113-145 km/h (70-90 mph)
Each speed range has 2 modes of low tire detection.

  • Monitor Mode 1
  • Monitor Mode 2 The EBCM learns the tire inflation configuration for each speed range independently. In Monitor Mode 1, the EBCM has only partially learned the tire inflation configuration for the speed range and has limited detection capability for a low tire condition. In Monitor Mode 2, the EBCM has fully learned the tire inflation configuration for the speed range and has full detection capability for a low tire condition. If the EBCM is not in Monitor Mode 1 or Monitor Mode 2, a low tire condition cannot be detected because the EBCM has not learned the tire inflation configuration of the vehicle.

To reset (calibrate) the system:
Turn the ignition switch to RUN. Then press and hold the RESET button for about five seconds. The red RESET button is located inside the instrument panel fuse block on the right side of the dash.. The LOW TIRE light will come on and flash three times and then it will turn off.
The system completes the calibration process during driving.
The system normally takes 15 to 20 minutes of driving in each of three speed ranges to "learn" tire pressures. The speed rages are 15 to 40 mph (25 to 65 km/h), 40 to 65 mph (65 to 105 km/h) and above 65 mph (105 km/h).

There you are, this should fix you up.
Keep in mind this system uses wheel speed sensors to calculate. If one of your sensors isn't working your low tire light will remain on.

Thank you for using FixYa.

KL

Jan 20, 2011 | 2000 Buick Century

2 Answers

The words tire reset keep on popping up on my dashboard. What does that mean, and how do I get rid of it? 2004 Ford Freestar.


With and without "Mesage Center" respectively (pretty sure)

With the engine on...

Push "Setup" button, until your driver display says something like "Press Reset for system check".

Then push Reset. The system check will start, rotating through a series of checks.

About the fifth or sixth check will be the tire pressure. The system will sound the tone (same one that starts w/the light) and It'll say something like "Check Tires Pressure" on that moment press and hold for 3 or 4 seconds Reset. When you release the Reset button It'll show "Hold Reset if tires are OK". While that's up, hold the Reset button. After 3 or 4 seconds, the tire warning light will blink 2 or 3 times and then will stop .You need to be ready for it, because you don't get very long to release.

How to reset the low tire pressure warning if the vehicle does not have the "Message Center"

Turn the ignition to the ON position,
depress and Trip/odometer button (located in the instrument cluster) until "TIRE RESET" or "CHECK TIRE AND RESET" is displayed in the odometer display window.
Once "TIRE RESET" or "CHECK TIRE AND RESET" is displayed, press and hold the button for three seconds.
The low tire warning indicator light will flash three times as the low tire warning system begins to initialize.

This information is in the Owners Manual

Hope it helps

Nov 04, 2010 | 2004 Ford Freestar

1 Answer

Check tire pressure light keeps coming on even when tire pressure


16 INCH OR BIGGER TIRES TIRE PRESSURE IS AT LEAST 44 PSI. YOUR TIRES PRESSURE STILL LOW.

Jun 14, 2010 | 2002 Cadillac Deville

1 Answer

Tire pressure light comes on


You shouldn't be setting the tire pressure to the max inflation pressure listed on the sidewall, that will likely result in uneven tire wear with the center of the tire wearing out prematurely. You should set the pressures according to the listings in the door jam. Most likely 32-34psi. Also, have you checked the spare tire? Some systems monitor and will illuminate the TPMS light if the spare tire pressure isn't within an acceptable range. The spare is often overlooked when checking tire pressures because of a TPMS indicator.

May 11, 2010 | 2005 Scion tC

2 Answers

Maintenence required light and tire pressure lights will not go off after oil change and tire rotation on my Toyota Highlander. How do I turn them off?


The maintenance light needs to be reset manually. See my Tips and Tricks on this website for additional information on how to reset it.

You should also check your spare tire for proper inflation. It will set the tire pressure light, as the spare is monitored also. If all 5 tires are OK, you may have a malfunctioning tire pressure sensor. If the tires have been changed recently, people with older tire machines have been known to break the sensors regularly, by mistake.

Aug 10, 2009 | 2009 Toyota Highlander

1 Answer

A light lit on my dashboard and I don't know what it means-2008 Nissan Rogue. It looks like an upside down horseshoe with the bottom of it jagged. Is this tire pressure/


YOUR VEHICLE HAS A TIRE PRESSURE LIGHT
THIS LIGHT COMES ON BRIEFLY WHEN THE ENGINE IS STARTED AND PROVIDES INFORMATION ABOUT TIRE PRESSURES AND THE TIRE PRESSURE MONITORING SYSTEM

Mar 12, 2009 | 2008 Nissan Rogue

Not finding what you are looking for?
2004 Mercury Montery Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...