Question about 2002 Honda Civic
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Its easy, look down behind the headlight assembly and where the wires go into the back of the headlight is the bulb. Its been a while, but you just unplug the connector and the bulb is held in by a locking ring or clip, I can't remember which.
The bulb is removed from the rear. Simply remove the bulb and install the new one and reconnect the connector.
Just don't touch the glass on the new bulb, because the oils in skin can create hot spots on the bulb.
Posted on Dec 31, 2008
SOURCE: srs lights on
safety restren system air bag problem have to get the car on a scanner to see the problem that the only thin g you can do now you can still drive the car but the air bag wont work
Posted on Feb 01, 2009
Bearings are pressed into the hubs...much easier, faster and economical (if you don't have a press) to replace the complete bearing/hub assembly, no pressing is needed, since bearings are already pressed into the new hubs. Cost..aprox, 60 buxs each.
Here are the steps for the rear replacement...
Loosen the lug nuts on a rear wheel. 2) Chock the wheels and jack the rear of the car on the side with the lug nuts that you just loosened. 3) Remove the wheel by removing the lug nuts. 4) Pry open the dust cap covering the center of the axle/spindle. A small screwdriver tapped into the space between the hub and dust cap will work well for this. 5) With the dust cap now removed, use a thin center punch to straighten the little dent in the rim of the spindle nut so that you will be able to turn it freely in the next step. 6) Use a 32mm socket and a large breaker-bar to loosen the spindle nut. Unscrew the nut all the way and place it in a clean, safe area. 7) You should now be able to slide the hub/bearing assembly from the shaft. 8) Installation is the reverse of removal. Use plenty of high-temperature wheel bearing grease on all surfaces before you mount the replacement hub assembly.
IMPORTANT: Torque the spindle nut to 134 ft/lbs....(per manual specs)
When reinstalling the dust caps, tap them gently into place to avoid denting them...Install wheels, jack her down and pat yourself on the back...job complete.
Good luck..hope this will fixya up...please take time to leave me a fixya rateing...
Posted on May 23, 2009
Tips for a great answer:
Nov 30, 2013 | 2002 Honda Civic
Sep 03, 2013 | Honda Civic Cars & Trucks
Sep 09, 2011 | 2002 Honda Civic
Mar 01, 2011 | 2002 Honda Civic
Nov 24, 2009 | 2000 Honda Civic
Aug 27, 2009 | 2001 Honda Civic
Jun 16, 2009 | 2002 Honda Civic
May 09, 2009 | 2002 Honda Civic
Apr 18, 2009 | 2002 Honda Civic
383 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: