Question about 1999 Buick Regal

1 Answer

WATER POORING FROM MY ENGINE

Hello
WATER IS POORING FROM MY ENGINE . WHAT IS THE PROBLEM ??

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 855 Answers

From what you say by pouring you may have a bad freeze plug. You would have to find the origin of the leak to be sure

Posted on Apr 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is the code p0473 for a dodge sprinter van 2008


Error Code: P0404
Fault Location:
Exhaust Gas Recirculation (EGR) System - Range/Performance Problem
Causes:
-Hose leak/blockage.
-Wiring harness.
-Exhaust gas recirculation (EGR) valve/solenoid.
Error Code: P0473
Discription:
Exhaust Gas Pressure Sensor - High Input
Causes:
- Wiring short to positive.
- Exhaust gas pressure sensor (G450).
- Engine control module (ECM).
Error Code: P0674
Description:
Glow Plug Cylinder 4 Circuit - Circuit Malfunction
Causes:
-No Pre-Glow Period.
-Poor Cold Starting.
-Glow Plug Wiring faulty.
-Poor connection.
-Relay.
-Glow plug control module.
-Glow Plug faulty.
-Engine control module (ECM).
Solutions:
Check Glow Plug Wiring.
Check Glow Plug.
Error Code: P0675
Description:
Glow Plug Cylinder 5 Circuit - Circuit Malfunction
Causes:
-No Pre-Glow Period.
-Poor Cold Starting.
-Glow Plug Wiring faulty.
-Poor connection.
-Relay.
-Glow plug control module.
-Glow Plug faulty.
-Engine control module (ECM).
Solutions:
-Check Glow Plug Wiring.
-Check Glow Plug.

Sep 20, 2014 | 2008 Dodge Sprinter

1 Answer

Car is overheating


Hello,
when the car overheats, is there still water in the radiator?
If there is water in the radiator and the car overheats, then it means there might be some dirt or blockage in the radiator or condenser.
When the car is on the motion, air passes through the front and assists the fan to cool the engine. there are situation whereby air doesn't have free flow because of blockage in the radiator and condenser. Dust and debris can cause blockage. If this be the case, have your radiator washed thoroughly and cleaned.
If there is no water in the radiator when the car overheats, then there is a probably a leakage from the water pump. Or maybe your fan isn't blowing properly. The fan might be blowing weak air.
The above are what could cause your engine to over heat.
So start the check from the radiator. Poor water into the radiator, wait for some minutes, look under the car and observe if water is going to leak. If there is a leak, it might be from the water pump or a leaking hose.
If water from radiator has no leak, have your radiator washed and clean the condenser has they might block air that is suppose to cool the engine.
Also, make sure your fan is blowing properly or well enough to cool the engine.
Make sure you have the above checked thoroughly as they are the major causes of problems like this.
This overheating problem could lead to a burnt gasket and this can dry the engine oil which will eventually knock the engine. So have this problem fixed to prevent further damage that will cost you more money.
Regards.

Sep 12, 2011 | 1993 Ford Tempo

1 Answer

Car is overheating


Hello,
when the car overheats, is there still water in the radiator?
If there is water in the radiator and the car overheats, then it means there might be some dirt or blockage in the radiator or condenser.
When the car is on the motion, air passes through the front and assists the fan to cool the engine. there are situation whereby air doesn't have free flow because of blockage in the radiator and condenser. Dust and debris can cause blockage. If this be the case, have your radiator washed thoroughly and cleaned.
If there is no water in the radiator when the car overheats, then there is a probably a leakage from the water pump. Or maybe your fan isn't blowing properly. The fan might be blowing weak air.
The above are what could cause your engine to over heat.
So start the check from the radiator. Poor water into the radiator, wait for some minutes, look under the car and observe if water is going to leak. If there is a leak, it might be from the water pump or a leaking hose.
If water from radiator has no leak, have your radiator washed and clean the condenser has they might block air that is suppose to cool the engine.
Also, make sure your fan is blowing properly or well enough to cool the engine.
Make sure you have the above checked thoroughly as they are the major causes of problems like this.
This overheating problem could lead to a burnt gasket and this can dry the engine oil which will eventually knock the engine. So have this problem fixed to prevent further damage that will cost you more money.
Regards.

Aug 11, 2011 | 1998 Chevrolet Malibu

1 Answer

Engine running ruff ,engine misfiring even after plug change ,wires changed rotor and distributor


check the map sen check for vacuum and check to see if at idle if removed vacuum from the map sens Eng should stall however it a known wit the distributor pick up coil to not put out a good signal to the coil their for poor spark and poor idle also check for water in fuel

Nov 11, 2010 | 1993 GMC Sierra K1500

4 Answers

My Explorer has the same coolant leak


Check closely where is it leaking from. If its coming out between the engine block and the cylinder head, very urgent depending how much is leaking, other like radiator or water pump can be temporary fix with sealer you buy at auto parts store although one has to monitor their engine temperature moore closely. Keep in mind any water leaks will cause nothing but overheat the engine. Water flow through out entire engine and cool the most important parts, the cylinder head where most heat created and need to be cool, if not the head can warp cause the head not to seat properly to the engine block, reaction would cause poor compression, rough idles, poor gas mileage, poor performance and ect. You can still drive the vehicle as long you pay attention to the temperature guage and the smell of the engine. You can smell if the engine is running hot, so just keep extra water container with you just incase you run low on fluid. Try not to run straight water in the systems, water reach it boiling point quicker than antifreeze.

Sep 02, 2009 | 1996 Ford Explorer

1 Answer

Advice on purchasing a 2005 Chrysler 300 Limited with 98000 miles


Hello scottym88...The chrysler 300 engine is the weak point on this vehicle, the 2.7 litre was a major headache for owners, dealers and Chrysler...the problem was due to engine sludge, poor oil circulation, poor crankcase ventilation, faulty timing chain tensioners...etc...From 1998-2004 the Chrysler 2.7L was prone to Oil Sludge often caused by internal coolant leakage that has to do with the design of the Water Pump that allows coolant to enter the Engine over time and causes oil sludge...result..ENGINE FAILURE. For 2005, changes included improvements to the PCV system and improved oil circulation, to even later increasing oil capacity by an extra quart in an attempt to make the engine more reliable... Unfortunately, even with all of these modifications premature engine failure is common. I've seen this first hand...and the really sad part is CHRYSLER knows...yet refuses to cover prematurely failed engines even when under its own 3 Year / 36,000 mile warranty while blaming consumers for these problems.
If you want to research this further, check out the consumer complaints on this vehicle and/or the 2.7 litre engine. I have been a MOPAR enthusiast all my life, and in my opinion this was the worst engine that chrysler ever released to the public.
Good luck...i hope this helps answer your question..please rate me a fixya.

Jul 27, 2009 | 2005 Chrysler 300

1 Answer

My honda civic 1996 (NOise)/ question?


take some water and poor it on the belt see if noise goes away.

Sep 28, 2008 | 1995 Honda Civic

1 Answer

Running like bag of spanners


Classic sign of a clogged up fuel filter. Diesels tend to filter out water from the fuel at a larger rate than gas engines. Look for the water separator and empty it, than you may have to move to the fuel filter. These symptoms you describe are all indicitive of a poor fuel condition.

Aug 06, 2008 | 2001 Volkswagen Golf

2 Answers

Stalling & hunting idle


does throttle sensor check out correctly???

Jun 10, 2008 | 1995 Volkswagen GTI

Not finding what you are looking for?
1999 Buick Regal Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...