Electric windows dont work. they are intermittent at best both are up now and I am afraid to use them for fear once down ill never get them back up. When I use the switch now nothing happens

Could be switch problem or electric motor behind door cover.

HIYA,IM AFRAID ITS AGE OLD ADDAGE,WITH AGE COMES
DETERIORATION.WHEN YOUR CLIMBING A HILL AND YOUR NEARLY AT THE TOP ITS JUST GETTING HARDER AND HARDER TO MOVE WHEN YOUR OLDER .ITS THE SAME AS YOUR WINDOWS ELECTRIC MOTOR ONCE FITTED IN FACTORY THEY RARELY GET SEEN AGAIN UNTIL THE CAR IS SCRAPPED.NOW AND AGAIN YOU GET ONE THAT ISNT QUITE
UP FOR IT ANYMORE AND THATS YOURS SORRY,ONE EASY AND INEVITABLE FIX FOR YOUR ISSUE?BUY A NEW MOTOR..THEY ARE SUPRISINGLY STRAIGHT FORWARD TO FIT ACTUALLY..WHY NOT TRY IT YOURSELF.,JUST MAKE SURE YOU MAKE NOTES AND THE DIAGRAM,FOR WHEN IT ALL HAS TO GO BACK IN
..GOOD LUCK
MARK/SWANSEA

On the actuating motor their is a small solenoid switch that needs to be sprayed with an electrical contact cleaner. It is also a thermal switch that will shut off power if something is binding the closing or opening of the window, and will come back on after about three minutes after it cools down.The best check is to slam the door pretty hard and see if that makes it work. That will pinpoint the problem as being in the door.

Sounds like a loose main connector on your wire harness. I say that because u say its intermittent

Could if knew what year , make , model an engine size ?

I would take out any fuses that I dont need running that kills the battery.

THE PROBLEM SOUNDS LIKE LOOSE WIRING CONECTIONS IN THE DRIVERS DOOR , BEST THING TO DO IS HAVE A LOOK OPEN UP DOOR PANEL AND CHECK ALL CONECTIONS, GOOD LUCK

http://wiki.answers.com/Q/How_do_you_remove_interior_door_panel_on_2000_stratus

try that link sorry its written down but for some reason the site wont let me insert it as a click here link.
If it dont work post back and ill give you another link to try.
This covers older versions but it will be the same concept as your model.

Let me know how you get on or if you need further assistance ok

If the link dont work then ill post several more or if you have any problems getting to the site then please let me know ok

Its time to stop being afraid of the unknown. there is no doubt that you will need to remove the inner door panel to access the electrical modules behind the buttons. https://www.youtube.com/watch?v=p2_f7NkjH8E hope this helps.

to get up pull on window with your hand while using switch in up position. if window is cocking to the side it is a bad window regulator. if it is just slow and then stopping probably a bad motor. it is harder to go up than down and this causes more pull on motor as it goes bad it will cause the breaker to heat up and trip so if you wait a few minutes you will see it tries to go up again.one quick way to check if motor is trying to work is to cut key on and watch your dome light when you work switch if it dims a little when you hit up button you know power is going to it. if not then possible switch problem.work you passenger window and look at light so you will see what i mean.