Need torque setting for rear hub assembly on 2003 Buick Rendezvous

already answered here, 26 or 29 :>D

What are the torque specs for crankshaft main and rod - Fixya

https://www.fixya.com > ... > Buick > LeSabre
Sept 21, 2012 - The connecting rods torque to 29 foot pounds. ... Where is the eng control module in a 2005 Buick Rendezvous ultra 3.6 eng.
SOLVED: I need torque specs. for rod bearings and main - Fixya
Jun 2, 2011
Torque specs for intake on 2005 buick rendezsous - Fixya
Sept 7, 2019
Torque spec for1997 3.8 buick rod and mains - Fixya
May 22, 2012
What is the torque specks for a 3.8 lt v 6 rear main cap 1987 buick ...
Nov 14, 2019
More results from www.fixya.com

More here

https://www.google.com/search?q=05+Buick+Rendezvous+Ultra+3.6+piston+rod+torque
..

I need more information, what engine for example. You should be able to get that information from any garage that can get the information from the car.

Answered but in general the bolts are 44 Ft. Lbs and 90 degree turn. In some cases replacement bolt kits will have the torque information on the box

192 lb. ft

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

YOU NEED A PULLER TO SEPARATE THE HUB FROM HALFSHAFT.

Hello: YES, You may have to loosen it with WD40 or knock it out with a hammer. (rust) clean up the cavity with sandpaper before installing new bearing.

Loosen the lug nuts. Jack up the car and pull off the wheel and brake drum.Unplug the electrical connector from the hub assembly Unscrew the four Torx head bolts that retain the hub assembly. Holes in the hub provide access to the screws. Remove the hub. Bolt the replacement hub assembly into place. Torque the Torx head bolts to 63 ft. lbs... and it would be best to realign after the work is done to ensure the "tow" is not off

You probably have a wheel hub/bearing going bad. Thes usually have sensors in them that will cause this issue.

Those are not nuts, they are bolts. The torque spec for those bolts is 52ft.lbs

get estimate from reputable mechanic take to several see what they say if work matches!!Then the most honest one and price is right use them!!! :)