Should be on the front side of the transmission, where the trans and engine connect. Follow the line from the master cylinder (should be next to the brake Master) down to the transmisson, it will lead you to the slave. It should look like a roll fo quarters with a plunger sticking out that attatches to a lever that goes inside the bell housing.
SOURCE: torque specs for 2004 kia rio cylinder head
youre going to torque it to 65 ft lbs.. start from the centre out and go diagonally. be sure to replace the head bolts and very lightly oil them before installation.
SOURCE: replace the water pump on a kia rio 2004
A little cramped but fairly easy. Email me at [email protected] and I can send you out the step by step instructions.
SOURCE: gear box oil filler plug - kia rio 2004
you have to take off the speedometer cable/wiring harness from the top of the trans and fill it from there....one 10mm bolt...very awkward spot...it might be snug, so just take a flat head screwdriver from underneath to tap it loose...
SOURCE: NO THIRD OR FORTH GEAR
Rebleed slave cylinder if you had third and fourth strong before. Do they catch when you're sitting with the car off and moving gears into position?
269 views
Usually answered in minutes!
×