SOURCE: procedures for replacing front shocks/struts on 1985 bmw 325e
are you changing the strut cartridge or the whole spring unit? if you are installing the whole unit, spring and all you will need no special tools, if not you will need a spring compressor
SOURCE: HOW COULD I READ CHECK ENGINE CODE ON A 1986 BMW 325E???
You can't use a tool to pull codes from an '87 BMW 325(e). You have the 2.7 liter and your DME, or computer is a Motronic. If you had a 325i, then a tool could read the codes because the computer was upgraded that year to a Motronic 1.1 system with a round plug in under the screw cap on the driver's side under the hood. The only tool you can buy is the one for resetting the service interval light and resetting the oil change light. To answer your question about going about finding your driveability problem would be to get a BMW Bentley Manual. This manual shows you how to use a standard voltmeter to check everything from your computer plug in. Your computer is located above the glovebox.
Good Luck,
~Stillin~
SOURCE: Reset ''Service Oil'' sensor on a 1985 BMW 325E off dash console
Call your local BMW dealer and ask them...should be free!
Good Luck
SOURCE: How to install front bumper cover on 2001 BMW E39
Installation
of the Molding
Take the Molding Trim whether it is
stock black or painted. Mine is black because my car is a year 2000.
Painted side moldings were done in the year 2001. Snap them into
place.
5 Installation
of the Rubber Gaskets
From the stock bumper, retrieve the upper
rubber gaskets unless you ordered new ones. Simply take a screw
driver and pry a corner off to get you started. Wash thoroughly.
NOTE which one belongs on which side.
Place the rubber gasket on the M5 Front Bumper onto
its appropriate side. Top
The M5 Bumper is now Fully Assembled!!!
Place aside where it can't be damaged.
SOURCE: Belt Diagram for 1986 BMW 325e
Ac is closest to the fan, Power Steering is in the Middle, and the Alternator belt is furthest from the fan (closest to the engine block)
391 views
Usually answered in minutes!
×