To change out turn lever - 1988 Jeep Cherokee

Remove or Disconnect
1. Make sure lever is in center of OFF position.
2. Electrical connection behind lever.
3. Switch lever by pulling straight out.

Install or Connect
1. Make sure switch lever is in center of OFF position.
2. Switch lever after aligning tab.
- Push straight in.
3. Electrical connection.

Inspect
- Test operation.

There is a small microswitch on the change lever assembly that has failed. This switch is used by the key interlock system to detect shift lever being put into Park position. The microswitch has not been available in the past as an indivfidual part but must be purchased with the entire change lever assembly.

The lever is part of the multifuntion switch located under the covers in the steering column. Disconnect the battery, remove the screws from the bottom cover [ has holes to access screws ], them it's held in with a couple screws. easy to change.

well its either the clip has come off of your hot cold lever so its not actually changing the temp or your missing the thermostat on your truck or your heater core could be plugged.the lever should not be turned easily it should have to have some pressure to it to turn

Inside the steering column, there will be a plastic like knob. This knob should be located right by the signal lever. It sounds like this knob has broken or worn down so that it doesn't snag the lever to cause it to turn off again. On some vehicles, the knob will be inside the lever assembly and this would mean that the entire signal arm will need to be changed. The arm should only be held in by 3 or 4 screws.

yes you can replace the lever.remove the plastic covering and look youll see how it on there.

Try spraying some CRC into this switch make fix the problem

The 2006 Vibe no longer has that feature. It was discontinued after 2005. I have the 2005 so I know how to change it. If your 2006 is able to change then here are the directions from my 2005.
Programmable Automatic
Door Locks
If you have an automatic transaxle, your vehicle is equipped with an auto door lock/unlock feature which enables you to program your power door locks.
Your vehicle left the factory programmed to Mode 4.
The following is a list of the available programming options:
Mode 1: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. There is no automatic door unlocking.
Mode 2: No automatic door locking or unlocking.
Mode 3: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. All doors and liftgate unlock when the shift lever is moved to PARK (P) with the ignition on.
Mode 4: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. All doors and liftgate unlock when the ignition switch is turned from ON to ACC or to LOCK.
To change the mode you are in, do the following:
1. Set the interior lamp control dial to the door position.
See Interior Lamps Control on page 3-16.
2. Move the shift lever into PARK (P) and close all doors and liftgate.
3. Turn the ignition to ON.
4. Within five seconds after the ignition is turned to ON, press and hold the power door lock switch in
the lock position for about five seconds.
5. The interior lamp will flash to indicate that the mode has been changed. For example, if the lamp flashes once, the function has been changed to Mode 1.
If the battery is disconnected or run down, the mode is changed to the initial mode which is Mode 4.

you have to release the clutch lever. take the bolt off of the clutch lever and take the lever off. this will release the clutch. I got mine loose but the only problem is how to reset it after you put the clutch back in.