Crank sensor? where is the crank sensor located?

This engine has two sensors, they are located in the side of the block and pick up the crank position from the crank throws. Below is a diagram. Make sure you check the connectors to the sensors for corrosion or fluid infiltration.

images for Where is crankshaft sensor location on 95 ...

eplaced engine on '97 SC300 now new engine does not have Crank ...

www.clublexus.com/.../633233-replaced-engine-on-97-sc300-now-new-...

May 4, 2012 - Location: arizona. Posts: 3 ... apparently 95-97s had an additional crank sensor. .... 1995 Lexus SC300 5spd Na-T ( TT Ecu Mod + a few others) 2jzge position sensor??
Nov 2, 2011
SC400 Crank Shaft Position Sensor. WHERE?????
Oct 11, 2011
SC300 No Spark
Oct 2, 2010
What happens if the Camshaft Position Sensor goes bad?
Jun 18, 2009
More results from www.clublexus.com

Lexus Crank Position Sensor ' LS400 SC300 ES300 GS300 ...

www.partsgeek.com > Crank Position Sensor > Lexus Parts & Accessories

Products 1 - 10 of 68 - 95 1995 Lexus LS400 Crank Position Sensor Denso NLA 7/13 ... 96 1996 Lexus SC300 Crank Position Sensor Denso Includes Pigtail.

is it a no crank or crank no start?
Possible causes for code P0335
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery

Read more: http://engine-codes.com/p0335.html#ixzz3Cxw6SN6O

Does it run? if so then the problem is not the crank sensor which is located above the starter motor in the tranasmission bell hopusing.

the sensor is most always located infront of the timng cover behind the crank pully or harmonic balancer on the crank shaft

The crank sensor is located on the top side of the transmission about 11:oo clock position

You will find the crank sensor near the turbo, you will need to remove the body and the gear box to locate the crank sensor.

The crank sensor is always located next to the crankshaft pulley. it will be inserted into the block with the top part of the housing half way out. you cant miss the wires leading into the tip of the housing next to the crank shaft pulley.

doesnt have one its inside the distributor

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?