What type of moon roof was installed on the 90

does your roof opening panel work (sun - moon roof ) ? Same fuse powers vent windows . fuse # 110 30 amp maxi fuse .

Check the connections to the motor for the moon roof. It's most likely that the motor has gone out, and will need to be replaced.

need the catalog service for check wiring then the switch

check the lights off delay check fuse for wipers or could be a bad wiper motor.

I have same problem. Below are a couple of suggestions from LincolnOnLine.com on how to close the sunroof manually. The first relates to a '93 and I'm not sure about the second. Use this info at your own risk. If you get a better answer, PLEASE POST IT HERE FOR ME. Thanks. Mort


Here is the text from my 93 Manual. There is an access panel in the rear centre of the headliner if it is the same as my 93.

Manual Operation

To close the sliding panel manually, remove the roof access hole trim panel located at the rear of the moon roof assembly. Remove the motor and bracket assembly as outlined to expose the splined shaft of the moon roof drive gear box. Using a typical corporate door window regulator crank handle properly set on the splined shaft, crank the moon roof panel closed.

Motor

CAUTION:
It is recommended that the battery ground cable be disconnected when removing or installing the moon roof motor assembly.


Removal and Installation

1. Operate glass panel until rear of glass panel is flush with sheet metal surface.

2. Remove motor access cover.

3. Remove two motor retaining screws.

4. Lower motor away from splined motor gear and disconnect electrical connector.

5. To install, reverse Removal procedure and synchronize motor as outlined under Adjustments.

Good Luck! __________________
Current:<P>1995 Town Car Executive 80K Miles<BR>1990 Mustang LX 2.3 Auto 62K<BR>1985 Chevrolet Caprice Estate Wagon X 2 (160K & 100K)<BR>1983 Chevrolet Caprice Sedan<BR>1984 Renault Turbo Fuego 60K<P>Past<BR> <BR>1980 Oldsmobile Cutlass<BR>1980 Chevrolet Citation<BR>1974 Triumph Spitfire<BR>1968 Triumph Spitfire<BR>1957 MGA<BR>1966 Renault R8<BR>1966 Renault R10<BR>1974 Chevrolet Malibu<BR>1968 Pontiac Firebird<BR>1966 Honda S600 Converible w Hardtop<BR>1978 Bobcat<BR>1969 Buick Last edited by Thanet; January 8th, 2007 at 07:07 PM. #3 January 8th, 2007, 07:26 PM Bill M. Registered User Join Date: January 8th, 2007 Location: Boston, MA Posts: 3 Moonroof Woes Thanks for the moonroof help. I might be getting a switch in the a.m. If not that remedy doesn't sound too bad. Bill M. #4 January 8th, 2007, 09:49 PM Tman70 Moderator Join Date: July 26th, 2004 Location: New York Posts: 2,757 1. Remove the roof headlining access hole cover located at the rear of the roof headlining.

2. Remove the sliding roof panel motor as outlined to expose the splined shaft of the sliding roof rail and guide.

3. Crank theroof sliding outer glass panel closed using a typical corporate door window regulator crank handle properly set on the splined shaft.

4. After performing these operations, remove crank handle and retime as outlined. Refer to «Adjustments, Motor Synchronization (Timing)» .

5. Install the sliding roof panel motor.

6. Tighten to 4-6 N-m (36-53 lb-in) and install roof headlining access hole cover. __________________

Take the moon roof control and get the sunroof all the way closed and then hold the button on for 7 seconds and see if that works.

look in the glove box ... there should be a crooked allen (hex) wrench in there...
The switch plate should then be popped off and the allen wrench inserted into the crank hole and when you turn the wrench it will crank the roof glass shut...

Lost as in how?
You said the switch is broken. Replace it. Jump the correct terminals to close the roof!

I suspect you need a roof module w/o the glass

car-part.com

I have the same car and had the same problem, when you pull down the head liner you will find the motor for the moon roof. i disconnected the motor so that i could analyze it. i found that the gears in the moon roof motor are made of plastic and most of the gear teeth were chewed off. i disconnected the wireing harness from the motor and left it unplugged, i then pushed the moon roof back into position and tightened the screws to the moon roof. That is the way i left it for the past 2 years, because i was not about to spend the money t fix the motor.