At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Passenger side fog lamp blew out, replaced with a new one of the same from factory and now it doesnt light up.. Driver side fog lamp works fine ... any clue?
Check the bulb, socket interface, clean contact points. IF you have a test light or ohmeter, check for power to the socket. If unpowered, check the fuse, if powered check bulb element, and socket condition.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
What fuse blew ? What did you hook up to for battery power for the fog lamps ? What aftermarket fog lamps ? Hope you know you can't just hook up aftermarket stuff just any old where . Your best bet , take it to a qualified repair shop. Let them see what you did wrong .
For the load side of relay, comes from fog lamp fuse. Voltage for control side of relay comes from fog lamp switch which gets voltage from headlamp switch.
There is three horns on a 2000 Chevrolet Silverado. One on the right side ( Driver's Side ) And two on the Passenger side behind the Fog light assembly that can be accessed by taking out the headlight, real easy to do. The drivers horn is down behind the fog lamp as well but is way harder to get to and I believe that one might be for the alarm factory installed. Good Luck. Robb
REPLACE THE FOG LAMP SWITCH DOWN ON THE STEERING COLM. REMOVE THE PROTEC. PANEL UNDER STEERING COLM. AND GENTLY START TO LOWER THE COLM. WATCH OUT FOR THE SHIFT IND. WIRE- REMOVE IT- LOWER COLM. AND HALF WAH DOWN ON THE TOP SIDE IS THE SWITCH FOR THE FOG LAMP CONTROL IF YOU HAVE ALREADY REPLACED THE ELEC. SWITCH - (PUSH BUTTON OR ROCKER STYLE ).IN THE DASH. IF - - LIGHTS AREON AND THE FOG LAMPS ARE TURNED ON AND THE HEAD LIGHT GO OUT OR WONT CHANGE FROM DIM TO BRIGHT REPLACE HIGH/LOW SWITCH ON COLM. SAME PROCEDURE AS FOG CONTOL SWITCH.
Sounds like similar problem I had on my older 93 - one side main beam and brake light not working. Turned out to be a problem with the filament testing relay. Got it resoldered and now ok.
To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light assembly, then you can remove the bulb and put a new one in.
To replace the fog light on the driver side you will need to remove the front bumper cover so you can remove the vacuum box that is in the the way of the fog light bolt.
To do so you need to remove the Torx (star) screws located in the front wheel wells as well as the bolts holding the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR."
If any of the screws are rusted into place put some penetrating oil them to help loosen them up.
check fuse #7 in the fuse block inside the vehicle and fuse #25 in the fuse block under the hood...more than likely you blew one of these fuses when it sparked. as for the drivers side being inop once you replace the blown fuse if you have a test light check for voltage at the bulb connector...the light assembly itself may be bad
×