Windsheild wipers not working, tried another wiper motor and fuses are ok am i missing a inline fuse or do i have to replace the switch?

Do you have int wipers? If so check the int module its under the dash right side of the steering column I believe. Specifically check the solder joints.

Learn how to test electrical circuits ! Find a wiring diagram so you know which wires to test . Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine size . Under system click on body & accessories , then under subsystem click on wipers / washers .Check B+ voltage and ground circuits .
Wiper Motor Switch Troubleshooting
Windshield Wiper Motor Wiring Tutorial

No relay in the circuit.
There is a delay module but if it fails that usually causes the wipers to stop in the middle of travel or only run on high.
And the switch is working if you hear noise coming from the motor. The wiper switch is not the same switch as the turn signals but it is near that assembly.
I would say if you have power to the wiper motor the motor is probably dead or something happened to the linkage to the arms.

Check wiper fuse. If ok turn key to on position and try to pull wiper arm into the direction that they would swipe on the windshield. If this doesn't work u could try tapping on the wiper motor while the key is on to see if that works. Use a test light to see if motor has power to it.

Hi guys I have a 09 f150 I replaced the combination switch for the wiper system and the wiper motor and I'm not getting any wipers. Checked all the grounds and fuses and can't find an issue can anyone please help?

Try checking your wiper fuse first. If the fuse checks out, make sure the motor is running. Check to make sure no wires are burnt around the motor or loose. If the motor checks out, it could be your wiper switch.

There is also a fuse module located on the passenger side of the center console under the dash. You can pull the plastic cover panel off by hand. This should be where the wiper motor fuse is located.

motor may be bad for the windshield wipers, you can disconnect and turn wipers on and see if blows the fuse, as it is in the switch then it should blow as soon as you turn them on. Hope this helps Tim

No wire harness or switch problem. Never a fuse

install an inline fuse of the same value, u can buy these at any auto parts store.