How to replace headlight on 2004 stratus rt coupe

Hi,

please ensure that you've recently had your oil changed at a neary jiffy lube or similar establishment. You can ask them to also check your break fluid and check whether that or other fluids in your vehicle would be the cause of the lunging issues. And as for the clicking, there might be friction within your wheel. As the oil-change personal if you need to add some oil to any internal part of the steering wheel or whether your power steering fluid is the issue.

Thank you.

https://www.autozone.com/repairguides/Avenger-Sebring-Coupe-Stratus-Coupe-1999-2006/Thermostat/Removal-Installation/_/P-0996b43f802d6a40

Replace the bulb it is blown.

Get a good 1/2" socket (don't remember the size) with a half-inch breaker bar and brace the handle of the bar so it won't move then get in and turn the key lightly, making sure you have the breaker bar in the way, just pop the key and the torque of the engine will bust that nut loose. There ya go.

to get your solution of your problem visit this site
Best Manuals

Sounds like you need the radio pulled and repaired at a authorized factory station.

If its a 2001+ Stratus Coupe first you need to remove the 2 bolts on the left and right sides of the lower middle dash assembly, these are at the very bottom of the assembly close to the center consuel (were your gearshift knob is. Once you remove those the assembly around your stero will come off. After that its just a matter of unbolting the stereo, sliding it out and removing the wireing harness in the back.
hope this helps

For 2004 Dodge Stratus 2.4L SFI SOHC 4cyl the Head Bolt Torque sequence
------------ | 10 6 2 3 7 | | 9 5 1 4 8 | ------------

Step: 1 - Torque to 25 ft/lbs
Steps: 2 - Torque to 50 ft/lbs
Steps: 3 - Torque to 50 ft/lbs
Steps: 4 - Turn 90 degreesRecheck final torque in sequence

Caution:Engine uses torque to yield head bolts (TTY) that permanently stretch during initial installation. New head bolts must be used when cylinder headis replaced or re installed to obtain proper torque specification.

Hope helps (remember comment and rated this).

Headlight Bulb Replacement
1. Open the hood and remove the two headlight mounting
screws.
2. Remove the push-in fasteners for the grill area by prying under the
head of the fasteners with a flat bladed tool.

part # bb086525aa at any mopar dealer LIST PRICE IS 137$